[cisco-voip] CCM4.1 to GK to MCU...

[Andreas Pentenrieder]

HI,

i would recommend you to use a "debug h225 asn1" debug to figure out, if the 
CCM trys to register with the gatekeeper (look for RRQ messages). If you can 
see RRQ message there should be a RRJ message. If so, get ride off the zone 
subnet command. By the way, the command isn't working, because there is no 
"no zone subnet enable default" command...

Of course you could provide the output of the debug command to us...then we 
can have a look!

Cheers,
Andi
----- Original Message ----- 
From: "Ryan Ratliff" <rratliff at cisco.com>
To: "Jonathan Charles" <jonvoip at gmail.com>
Cc: "Cisco Voip" <cisco-voip at puck.nether.net>
Sent: Monday, October 30, 2006 8:42 PM
Subject: Re: [cisco-voip] CCM4.1 to GK to MCU...


> Check that zone subnet command.  I'm pretty sure it restricts what IP
> addresses the gatekeeper will allow registration from.  Also check
> out 'debug ras', 'debug h225 asn1', and 'debug gatek main 10'.
>
> -Ryan
>
> On Oct 30, 2006, at 1:52 PM, Jonathan Charles wrote:
>
> There is a route-pattern pointing to the trunk, but the Gatekeeper
> only shows the MCU registered as an endpoint.
>
> The CM is set to register as a gateway... and the CM is not on the
> same subnet...
>
>
>
> Jonathan
>
> On 10/30/06, Ryan Ratliff <rratliff at cisco.com> wrote: You have to
> have a route pattern pointing to the trunk for CM to
> register with the gk afaik.  Also note that CM only retries
> registration every 30-60 seconds.  For quicker results reset the gk-
> controlled trunk.  Also make sure you have CM set to register as a
> gateway not a terminal.
>
> From your config I assume CM's IP address falls within the
> 10.1.1.0/22 subnet?
>
> -Ryan
>
> On Oct 30, 2006, at 12:38 PM, Jonathan Charles wrote:
>
> OK, I have a CCM4.1 box, and I am trying to get it to connect (for
> video) to a Cisco MCU, via a gatekeeper...
>
> The MCU is registered to the gatekeeper as an endpoint, but I can't
> get the CCM to do the same...
>
> I have a gatekeeper controlled trunk pointing at the MCU (with the GK
> identified)...
>
> Still nothing...
>
> I also added a couple of route-patterns (with the MCU service
> prefixes) pointing at the trunk... Still nothing...
>
>
> gatekeeper
>   zone local 10.1.1.1 binky.com
>   zone subnet 10.1.1.1 10.1.1.0/22 enable
>   zone prefix 10.1.1.1 2125554244*
>   gw-type-prefix 1#* default-technology
>   no shutdown
>
>
>
> Any ideas?
>
> TIA
>
>
>
> Jonathan
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>