[cisco-voip] Routing a PRI Number

[Jonathan Charles]

Well, the easiest thing to do is to put x1212 on all three phones as a
shared line.

However, let's do what you mentioned.

Create a line group, add those three numbers to it.

Create a Hunt List, add the line group to it.

Create a hunt pilot, give it x1212 and point it at the HL you created above.

Reset stuff.

Done.

Remember, if the gateway is under the control of CCM (or is H.323 with a
voip dial-peer pointing at CCM), the only thing you need to do is match the
digits you are receiving from telco to a DN/HP/TP/RPat/RPoint on CCM.


Jonathan

On 4/6/07, Todd Franklin <toddnh65 at gmail.com> wrote:
>
> I posted a start on this a while back, and your answers were helpful!  But
> I think I am stuck!
>
> I have a PRI line.  We have a flat network that interconnects 4 buildings
> with one CCM and Unity box running the show.
>
> So someone calls in, 555-1212.  I have my telco ready to move 1212 to the
> PRI, so I should be able to tell CCM to grab that
> pretty easy.  When 1212 comes in, I want to ring extensions 3200, 2301,
> and 3202.  I think this is where I am stuck.
>
> Do I setup a Line Group?  A Hunt List?  Where do I go from here?
>
> Thanks.
>
> Todd
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070406/9f5a5318/attachment.html