[cisco-voip] Carve out a T1

[STEVEN CASPER]

 We have some old Aspect systems that communicate across standard point
to point T1 circuits. Is there any way to carve out a T1 from an IP MAN
to support this as opposed to ordering carrier circuits? I am familiar
with Transparent Common Channel Signaling (T-CCS) but that uses a
specific time slot for signaling. I think the Aspect uses a proprietary
method. 

 Is there a way I could configure a DS0 group at each site where an
Aspect is present and nail up the 24 timeslots between the 2 DS0
groups?

Thanks,

Steve Casper
Voice Technologies
M&T Bank
(410) 347-6026

************************************
This email may contain privileged and/or confidential information that is intended solely for the use of the addressee.  If you are not the intended recipient or entity, you are strictly prohibited from disclosing, copying, distributing or using any of the information contained in the transmission.  If you received this communication in error, please contact the sender immediately and destroy the material in its entirety, whether electronic or hard copy.  This communication may contain nonpublic personal information about consumers subject to the restrictions of the Gramm-Leach-Bliley Act and the Sarbanes-Oxley Act.  You may not directly or indirectly reuse or disclose such information for any purpose other than to provide the services for which you are receiving the information.
There are risks associated with the use of electronic transmission.  The sender of this information does not control the method of transmittal or service providers and assumes no duty or obligation for the security, receipt, or third party interception of this transmission.
************************************