[cisco-voip] Firmware 8.2.2sr1

[Voll, Scott]

Thanks Ryan..... This is what is happening..... I've been looking
through my network and banging my head (it helps) and finally found that
my 3550 12g layer 3 switch doesn't have any QoS.  It's running
12.2.35see2.

Can't you run the auto QoS command on these?  Am I entering the wrong
command?  Or do I have to manually do this?

TIA

Scott

-----Original Message-----
From: Ryan Ratliff [mailto:rratliff at cisco.com] 
Sent: Thursday, April 26, 2007 9:12 AM
To: Voll, Scott
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Firmware 8.2.2sr1

"CM Down, features disabled" is the message you get on the phone when  
it loses the TCP session to the active CM but is on a call, so the  
phone does not fail over.   Resetting the phone from CCMAdmin will  
not do anything since the phone will wait until the active call is  
dropped before resetting.

If you are getting that message when not on a call then that is very  
odd.

-Ryan

On Apr 26, 2007, at 12:04 PM, Voll, Scott wrote:

Has anyone seen this problem.



Phone cuts out and shows "CM Down, feature disabled"  I see no  
network issues.  It's on the local network.  Gig ever where.



It seems to have broke at about the same time I upgraded from 7.x to  
the 8.2.2sr1.



I seen a bug but it was for a earlier version.



A reset has not seem to have fixed the issue



TIA



Scott

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip