[cisco-voip] CCVP Lab Equipment

Mon Dec 3 13:04:36 EST 2007

In addition to that, the config will designate one gateway as the network side and the other as the user, also one would provide clocking and the other will receive.

This would look like:

Network side router:
controller T1 0/1/0
 clock source internal
 pri-group timeslots 1-24

interface Serial0/1/0:23
 no ip address
 isdn switch-type primary-ni
 isdn protocol-emulate network
 isdn incoming-voice voice
 no cdp enable

User side router:
controller T1 0/1/0
 pri-group timeslots 1-24

interface Serial0/1/0:23
 no ip address
 isdn switch-type primary-ni
 isdn incoming-voice voice
 no cdp enable

You will then have PRI configured and running (verify by 'show isdn status') and you can put some dial peers in place.

HTH,

------------------------------------------- 
thanks, 
Avner Izhar 
CCIE#15999 (Voice), CCVP, CCSI# 31623 
Technical Instructor 
CCBOOTCAMP - A Cisco Sponsored Organization (SO) 
Email: aizhar at ccbootcamp.com 
Toll Free: 877-654-2243 
Direct: +1-702-968-5100 = Outside the USA 
FAX: +1-702-446-8012 
YES! We take Cisco Learning Credits! 
Training And Remote Racks: HYPERLINK "http://www.ccbootcamp.com/"http://www.ccbootcamp.com 

   _____  

From: Brad Ellis 
Sent: Sunday, December 02, 2007 15:45
To: David Lin; Manoj Kalpage; Avner Izhar
Cc: cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] CCVP Lab Equipment [bcc][faked-from]

Make a PRI/T1 crossover cable by taking pins 1,2 to 4,5 and pins 4,5 to 1,2 respectively. (ie, you are just crossing two pairs). 

thanks,

Brad Ellis

CCIE#5796 (R&S / Security)

CCSI# 30482

CEO / President

CCBOOTCAMP - A Cisco Sponsored Organization (SO)

Email: HYPERLINK "mailto:brad at ccbootcamp.com"brad at ccbootcamp.com

Toll Free: 877-654-2243

International: +1-702-968-5100

Sydney, Australia: +61 2 8080 2725

Toronto, Canada: +1-416-238-0441
Skype: skype:ccbootcamp?call

FAX: +1-702-446-8012

YES! We take Cisco Learning Credits!

Training And Remote Racks: HYPERLINK "http://www.ccbootcamp.com/"http://www.ccbootcamp.com

Routing and Switching Forums: HYPERLINK "http://www.routerie.com/"http://www.routerie.com

Security Forums: HYPERLINK "http://www.securityie.com/"http://www.securityie.com

Voice Forums: HYPERLINK "http://www.voiceie.com"http://www.voiceie.com

   _____  

From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of David Lin
Sent: Sunday, December 02, 2007 2:38 PM
To: Manoj Kalpage; Avner Izhar
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] CCVP Lab Equipment [bcc][faked-from]

Definitely, you have to loop back two PRI interfaces by a cross PRI calbe.

> Date: Mon, 3 Dec 2007 00:17:12 +0900
> From: manoj.kalpage at gmail.com
> To: aizhar at ccbootcamp.com
> CC: cisco-voip at puck.nether.net
> Subject: Re: [cisco-voip] CCVP Lab Equipment
> 
> Avner,
> If you don't mind could you explain how to make PRI emulator using
> back to back PRI? Do I need two PRI interfaces for this? Any
> information would be appreciated.
> 
> Regards,
> MK
> 
> On Nov 30, 2007 2:59 AM, Avner Izhar <aizhar at ccbootcamp.com> wrote:
> >
> >
> > Hi Syed,
> >
> > CCVP has 4.x and 5.x in it, you should probably go for call manager 5.x,
> > works well on vmware but the licensing might be tricky .
> >
> > Unity 4.x can be installed on any platform, but it is not in the CCVP
> > curriculum (aside from the TUC). CUE is not in there at all.
> >
> > The installations will not be supported by cisco, but can be used for
> > training proposes.
> >
> > PRI emulators can be replaced by using a back to back pri connection on a
> > router, just make sure you take care of clocking and protocol emulation.
> >
> > HTH,
> >
> >
> >
> > -------------------------------------------
> > thanks,
> > Avner Izhar
> > CCIE#15999 (Voice), CCVP, CCSI# 31623
> > Technical Instructor
> > CCBOOTCAMP - A Cisco Sponsored Organization (SO)
> > Email: aizhar at ccbootcamp.com
> > Toll Free: 877-654-2243
> > Direct: +1-702-968-5100 = Outside the USA
> > FAX: +1-702-446-8012
> > YES! We take Cisco Learning Credits!
> > Register to win a free iPhone! http://www.ccbootcamp.com/iphone.html
> >
> > ________________________________
> > From: cisco-voip-bounces at puck.nether.net
> > [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Syed Khalid Ali
> > Sent: Thursday, November 29, 2007 09:29
> > To: cisco-voip at puck.nether.net
> > Subject: [cisco-voip] CCVP Lab Equipment [bcc][faked-from]
> >
> >
> >
> >
> > Hi to all,
> >
> > Currently I have CCM 4.1(3) running on vmware virtual machine (on Dell
> > Optilex GX-270). 2611, 2651XM, 2821 routers.
> > 2xFXO (for 2600 series). 2xFXS (2600 series). CCME 3.3. 1xPRI card(which is
> > useless since no PRI lines to work with).
> > 3xISDN BRI cards . 2-port ISDN BRI emulator. 1x 3560 24Port PoE EMI. 1x
> > 3560 24Port EMI.
> >
> > Now my boss will be ordering NFR for security guys in January 2008 and
> > asking me if any thing i need in lab.
> > Should I include CCM 5.0 or CCM 6.0 software, which one is better. Also do I
> > need to have an MCS server .
> > Does CCM5/6 install and run without problems on vmware.
> > And what about PRI emulators, Unity Express or Unity. Also Does Unity
> > requires an MCS server to run.
> >
> >
> >
> >
> >
> > regards,
> >
> > syed khalid ali
> >
> >
> > No virus found in this incoming message.
> > Checked by AVG Free Edition.
> > Version: 7.5.503 / Virus Database: 269.16.10/1159 - Release Date: 11/29/2007
> > 11:10
> >
> >
> >
> > No virus found in this outgoing message.
> > Checked by AVG Free Edition.
> > Version: 7.5.503 / Virus Database: 269.16.10/1159 - Release Date:
> > 11/29/2007 11:10
> >
> > _______________________________________________
> > cisco-voip mailing list
> > cisco-voip at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-voip
> >
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip

   _____  

HO HO HO, if you've been naughty this year, email Santa! HYPERLINK "http://asksanta.ca/?icid=SANTAENCA005"Visit asksanta.ca to learn more!

No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.503 / Virus Database: 269.16.13/1164 - Release Date: 12/2/2007 11:30

No virus found in this outgoing message.
Checked by AVG Free Edition. 
Version: 7.5.503 / Virus Database: 269.16.13/1167 - Release Date: 12/3/2007 12:20

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20071203/5dcf49c9/attachment-0001.html 