[cisco-voip] VG224 and Polycom`s

[Jonathan Charles]

I just ran into this, you also need to upgrade the VG224 to a T train
of 12.4... and add these commands:

stcapp feature access-code
!
stcapp call-control mode feature



Jonathan

On Dec 17, 2007 4:30 AM, wayne jackson <wayne-jackson at hotmail.co.uk> wrote:
>
>  I have several VG224 working on MGCP with analogue Polycom`s conference
> phones however we are unable to set up a conference call from the actual
> phone, if I establish a call and then try to use the hookflash to place the
> call on hold and then set up a conference it cuts the original person off.
> The setting on CCM is max. 1 call which makes sense with the current fault
> but I`m unable to increase it. The only info. I`ve seen points to SCCP
> control of the VG`s if I need analogue conference set up not MGCP - is this
> correct ?. - thanks
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>