[cisco-voip] CME map incoming pri to ip phones

[Jim McBurnett]

I would add one note to that..
And I use num-exp too...

If you use 4 digits on both sides-- it makes the changes for ALL calls.
IE say you have an ext 4500 via an h.323 dial peer..
And you have a DID incoming as 4500 to translate to 2333.
ALL calls to 4500 become 2333...
I had to t/s a customer modification that did this..
And it was one of 90 num-exp in the system- I think my eyes were too tired to see it at first..

With a translation profile-- you can direct it based on the incoming dial-peer.

Think of num-exp as the 20 ld sledge hammer and translation profiles as the 15 oz finishing hammer....


Later,
Jim


-----Original Message-----
From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jonathan Charles
Sent: Tuesday, December 18, 2007 10:47 AM
To: cisco.voip
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] CME map incoming pri to ip phones

Easier way, use num-exp...

So, do this:

num-exp 4071111101 2001
num-exp 4071111102 2002

etc....



Jonathan

On Dec 17, 2007 11:11 PM, cisco.voip <cisco.voip at verizon.net> wrote:
> Hello, I have setup CME and have 4 - 7960 ip phones with extension
> 2001-2004.
> I have a PRI connected to a PRI Simulator to some pstn ports.  Outbound dial
> works fine, however how do I
> map the incoming pri numbers 4071111101-4071111104 to the ip phone
> extensions 2001-2004?
>
> TIA
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip