[cisco-voip] CME map incoming pri to ip phones

[cisco.voip]

I used the num-exp, however, when I call in from pstn side, I get a dialtone 
from which I dial 2001 and ring the ip phone.
Why does the router provide this dial tone?

----- Original Message ----- 
From: "Jonathan Charles" <jonvoip at gmail.com>
To: "Jim McBurnett" <jim at tgasolutions.com>
Cc: "cisco. voip" <cisco.voip at verizon.net>; <cisco-voip at puck.nether.net>
Sent: Tuesday, December 18, 2007 3:33 PM
Subject: Re: [cisco-voip] CME map incoming pri to ip phones


> 90, that's it?
>
> We have a cust where we have to do almost 200 per site...
>
>
> Jonathan
>
> On Dec 18, 2007 10:47 AM, Jim McBurnett <jim at tgasolutions.com> wrote:
>> I would add one note to that..
>> And I use num-exp too...
>>
>> If you use 4 digits on both sides-- it makes the changes for ALL calls.
>> IE say you have an ext 4500 via an h.323 dial peer..
>> And you have a DID incoming as 4500 to translate to 2333.
>> ALL calls to 4500 become 2333...
>> I had to t/s a customer modification that did this..
>> And it was one of 90 num-exp in the system- I think my eyes were too 
>> tired to see it at first..
>>
>> With a translation profile-- you can direct it based on the incoming 
>> dial-peer.
>>
>> Think of num-exp as the 20 ld sledge hammer and translation profiles as 
>> the 15 oz finishing hammer....
>>
>>
>> Later,
>> Jim
>>
>>
>>
>> -----Original Message-----
>> From: cisco-voip-bounces at puck.nether.net 
>> [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jonathan Charles
>> Sent: Tuesday, December 18, 2007 10:47 AM
>> To: cisco.voip
>> Cc: cisco-voip at puck.nether.net
>> Subject: Re: [cisco-voip] CME map incoming pri to ip phones
>>
>> Easier way, use num-exp...
>>
>> So, do this:
>>
>> num-exp 4071111101 2001
>> num-exp 4071111102 2002
>>
>> etc....
>>
>>
>>
>> Jonathan
>>
>> On Dec 17, 2007 11:11 PM, cisco.voip <cisco.voip at verizon.net> wrote:
>> > Hello, I have setup CME and have 4 - 7960 ip phones with extension
>> > 2001-2004.
>> > I have a PRI connected to a PRI Simulator to some pstn ports.  Outbound 
>> > dial
>> > works fine, however how do I
>> > map the incoming pri numbers 4071111101-4071111104 to the ip phone
>> > extensions 2001-2004?
>> >
>> > TIA
>> >
>> >
>> > _______________________________________________
>> > cisco-voip mailing list
>> > cisco-voip at puck.nether.net
>> > https://puck.nether.net/mailman/listinfo/cisco-voip
>> >
>> _______________________________________________
>> cisco-voip mailing list
>> cisco-voip at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>
>