[cisco-voip] CME map incoming pri to ip phones

[cisco.voip]

Excellent, thanks, I had to enter the command under the pots dial peer.
  ----- Original Message ----- 
  From: Wes Sisk 
  To: cisco.voip 
  Cc: Jonathan Charles ; Jim McBurnett ; cisco-voip at puck.nether.net 
  Sent: Tuesday, December 18, 2007 10:31 PM
  Subject: Re: [cisco-voip] CME map incoming pri to ip phones


  add 'direct-inward-dial' under your d-ch serial interface:
  int s1/0:23
  direct-inward-dial

  /Wes

  cisco.voip wrote: 
I used the num-exp, however, when I call in from pstn side, I get a dialtone 
from which I dial 2001 and ring the ip phone.
Why does the router provide this dial tone?

----- Original Message ----- 
From: "Jonathan Charles" <jonvoip at gmail.com>
To: "Jim McBurnett" <jim at tgasolutions.com>
Cc: "cisco. voip" <cisco.voip at verizon.net>; <cisco-voip at puck.nether.net>
Sent: Tuesday, December 18, 2007 3:33 PM
Subject: Re: [cisco-voip] CME map incoming pri to ip phones


  90, that's it?

We have a cust where we have to do almost 200 per site...


Jonathan

On Dec 18, 2007 10:47 AM, Jim McBurnett <jim at tgasolutions.com> wrote:
    I would add one note to that..
And I use num-exp too...

If you use 4 digits on both sides-- it makes the changes for ALL calls.
IE say you have an ext 4500 via an h.323 dial peer..
And you have a DID incoming as 4500 to translate to 2333.
ALL calls to 4500 become 2333...
I had to t/s a customer modification that did this..
And it was one of 90 num-exp in the system- I think my eyes were too 
tired to see it at first..

With a translation profile-- you can direct it based on the incoming 
dial-peer.

Think of num-exp as the 20 ld sledge hammer and translation profiles as 
the 15 oz finishing hammer....


Later,
Jim



-----Original Message-----
From: cisco-voip-bounces at puck.nether.net 
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jonathan Charles
Sent: Tuesday, December 18, 2007 10:47 AM
To: cisco.voip
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] CME map incoming pri to ip phones

Easier way, use num-exp...

So, do this:

num-exp 4071111101 2001
num-exp 4071111102 2002

etc....



Jonathan

On Dec 17, 2007 11:11 PM, cisco.voip <cisco.voip at verizon.net> wrote:
      Hello, I have setup CME and have 4 - 7960 ip phones with extension
2001-2004.
I have a PRI connected to a PRI Simulator to some pstn ports.  Outbound 
dial
works fine, however how do I
map the incoming pri numbers 4071111101-4071111104 to the ip phone
extensions 2001-2004?

TIA


_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

        _______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

      

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20071218/9500d438/attachment.html