[cisco-voip] CCM shared line like in CME

[Patrick Mowry]

That's the way I would do it too.

-Patrick

-----Original Message-----
From: Voll, Scott [mailto:Scott.Voll at wesd.org] 
Sent: Thursday, January 04, 2007 4:58 PM
To: Jozef Janitor; Patrick Mowry; cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] CCM shared line like in CME

Setup a Broad cast LineGroup... assign it to a Hunt Group and then to a
Hunt pilot.  It will work much the same way.

Scott

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jozef Janitor
Sent: Thursday, January 04, 2007 2:43 PM
To: 'Patrick Mowry'; cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] CCM shared line like in CME

We have an office where each of us has its own IP phone at the desk with
own
extension, but we would like also to have one shared number for this
office.

There are already no free buttons on the phones, so that's the reason
why I
would like to have to one button assigned two extensions.

Is it possible?

Thank you.

Jozef


> -----Original Message-----
> From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-
> bounces at puck.nether.net] On Behalf Of Patrick Mowry
> Sent: Thursday, January 04, 2007 11:13 PM
> To: cisco-voip at puck.nether.net
> Subject: Re: [cisco-voip] CCM shared line like in CME
> 
> Just out of curiosity, what is it you are trying to do?
> The only time I have used an overlay button in CME was to simulate the
> operation of a broadcast hunt group that is native to CM, but not in
> CME.
> 
> -Patrick
> 
>   ----- Original Message -----
>   From: Jozef Janitor
>   To: cisco-voip at puck.nether.net
>   Sent: Thursday, January 04, 2007 2:56 PM
>   Subject: [cisco-voip] CCM shared line like in CME
> 
> 
>   Hi,
> 
> 
> 
>   Is it possible to configure the "big" CCM (4.x) to have a shared
line
> feature assigned to a button?
> 
>   I am creating these shared lines on CME this way:
> 
> 
> 
>   ephone-dn 1
> 
>    number 1000
> 
>   ephone-dn 2
> 
>    number 1001
> 
>   ephone 1
> 
>    mac-address 1234.5678.1234
> 
>    type 7940
> 
>    button 1o1,2
> 
> 
> 
>   But in CCM configuration I can't see a possibility to assign another
> DN to a line.
> 
>   Do you have any suggestion please?
> 
> 
> 
>   Thank you.
> 
> 
> 
>   Best regards,
> 
>      Jozef Janitor
> 
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip