[cisco-voip] CME - CUE configuration

[Mike Reilly]

Figured it out. My dialplan pattern command was sending all 10 digits
  ----- Original Message ----- 
  From: sweeper1 
  To: Mike Reilly 
  Sent: Tuesday, July 17, 2007 10:34 PM
  Subject: Re: [cisco-voip] CME - CUE configuration


  you have to associate the number with the mailbox... if you associate the phone it usually works... but if you used the telephony-service setup command to setup your CME it will ask you what the beginning of your DID range is 4045551... and it will put a command under telephony-service that prepends those digits... so if you called VM from extension 1111 it would hit unity as 4045551111, so you can either take out that command in telephony-service...or go into the CUE mailbox and add 4045551111 as the E164 number associated to that box.... 

  Steve

   
  On 7/17/07, Mike Reilly <reillyipt at gmail.com> wrote: 
    Having issues with a cme cue configuration.  When I press the voicemail button on the phone goes to cue and says please enter your id. I am on a phone that has a cue mailbox.  When i call the phone and do not answer i get a busy signal. 

    If i put in the id when pressing the voicemail button I get for security reasons you must configure this mailbox from the primary mailbox.

    Any ideas?  Can i see the way the call is being forwarded to vm? meaning the digits being forwarded?

    _______________________________________________
    cisco-voip mailing list 
    cisco-voip at puck.nether.net
    https://puck.nether.net/mailman/listinfo/cisco-voip



-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070718/129d4fbc/attachment.html