[cisco-voip] outbound faxing issues

[Jonathan Charles]

Try:

mgcp fax-rate 9600

Also follow Scott's recommendations...

Also, if they are ATAs, and only one device is attached, disable the other port.



Jonathan

On 6/4/07, James Grace <jgrace at adcapnet.com> wrote:
> ?
>
>
> we are sending faxs outbound and they are all getting disconnected.
> incomming faxes are fine.  we are runing CM (mgcp) with fxo 4port card.  i
> not sure what to look at for fax. up until now they all just work if mgcp
> was config correctly.
>
>
>
> James Grace
>
> Systems Engineer
> Adcap Network Systems, Inc.
> 6865 Shiloh Road East, Suite 250
> Alpharetta, GA 30005
>
> office: 678-456-6986
> direct: 678-456-6761
> jgrace at adcapnet.com
> www.adcapnet.comDisclaimer For ADCAP Network Systems
>
> "The information transmitted is intended only for the person or entity to
> which it is addressed and may
> contain confidential and/or privileged material. Any review, retransmission,
> dissemination or other use of,
> or taking of any action in reliance upon this information by persons or
> entities other than the intended
> recipient is prohibited. If you received this message in error, please
> contact the sender and delete the
> material from all computers."
>
> This original email was sent to the internet for delivery at 04 Jun 2007
> 17:32:01 -0400
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>