[cisco-voip] E1 unbalanced cable for MFT interface?

[Vince Loschiavo]

You should be able to get this from a local cabling vendor.   

 

Keep in mind the impedance differences between coax and cat 5/6. 

 

____________________________________________________________
Vincent Loschiavo
Senior Consultant
Datacorp
18503 Pines Blvd, Suite 212, Pembroke Pines, FL, 33029
"Cisco Advanced Unified Communications Partner"
Cell Phone:        786-282-1164
Office Phone:    305-594-6933
____________________________________________________________ 

________________________________

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jason Aarons
(US)
Sent: Tuesday, June 12, 2007 8:42 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] E1 unbalanced cable for MFT interface?

 

Telco delivered a E1, has two BNC male cables.

 

I need a BNC Female to RJ-48 cable for my VWIC2-MFT-T1/E1, Cisco doesn't
make this, anyone have a cable supplier I can order from? I'm trying not
to use barrel connectors, etc. I'm also thinking about a custom cable
assembly if I have to..not sure of pinouts...

 

________________________________

Disclaimer: This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the designated
addressee(s) named above only. If you are not the intended addressee,
you are hereby notified that you have received this communication in
error and that any use or reproduction of this email or its contents is
strictly prohibited and may be unlawful. If you have received this
communication in error, please notify us immediately by replying to this
message and deleting it from your computer. Thank you. 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070612/8eb8f3af/attachment.html