[cisco-voip] 2801 MGCP Gateway on CCM 5.0

Fri Mar 2 17:53:45 EST 2007

The first line of 'show ccm' output is the full MGCP domain name. This needs to match what CCM has.

----- Original Message ----
From: omar parihuana <omar.parihuana at gmail.com>
To: Jonathan Charles <jonvoip at gmail.com>
Cc: cisco-voip at puck.nether.net
Sent: Friday, March 2, 2007 2:24:01 PM
Subject: Re: [cisco-voip] 2801 MGCP Gateway on CCM 5.0

Hi,

Maybe you can disble ip domain name and use only IP address in CCM and Gateway,

with sh ccm you must see the registration.

Rgds. 

On 3/2/07, 
Jonathan Charles <jonvoip at gmail.com> wrote:
In CCM, you need to setup the gateway name as:

GW2801.test.br

This is your hostname and your ip domain name...

There is no other method.

When you say it is 'active' on the gateway, that doesn't correspond to what it should say...

If you do a:

show ccm

you should see it say primary and registered.

And then on CCM, click on show endpoints and you should see a 'registered with...' if it is up.

Jonathan

On 2/28/07, alsvrj <
alsvrj at superig.com.br> wrote:

Hello All,

I have an 2801 connected to a Hicom 330 PBX through a ISDN PRI QSIG with

MGCP and a CCM5.0
. I´m having a lot of problems to get the gateway
registration on CCM.

I would like to do some questions:
1- Is it possible to put an ISDN PRI with MGCP using QSIG signaling ?

Using the show isdn status command I´m seeing MULTIPLE_FRAME_ESTABILISHED

I´m seeing too with the show ccm-manager that the MGCP is Active but I´m not
able to see this Gateway into the active state inside of CCM.

I´m using a VWIC-1MFT-E1 card to use this ISDN PRI.

2- Is it possible to put the IP Address instead of Domain Name when I´m

creating the 2801 Gateway ?

Hey guys, I really need your help to solve this registration problem, I
kindly ask a hand into this situation.

Thanks for everything.

It follows below the configuration on the Gateway:

hostname GW2801
!
boot-start-marker
boot system flash c2801-adventerprisek9-mz.124-6.T3.bin
boot-end-marker
!
logging buffered 4096 informational
enable secret 5 ********************
!

no aaa new-model

!
resource policy
!
clock timezone UTC -3
network-clock-participate wic 2
network-clock-select 1 E1 0/2/0
ip cef
!
!
!
!
ip tcp synwait-time 13
no ip domain lookup
ip domain name 
test.br
ip name-server *.*.*.*
ip name-server *.*.*.*
ip name-server *.*.*.*
!
isdn switch-type primary-qsig

isdn logging
!
voice-card 0
dsp services dspfarm
!

!
voice call carrier capacity active
!
!
voice class codec 1
codec preference 1 g711ulaw
codec preference 2 g729r8 bytes 40
!
!
!
voice class h323 1
h225 timeout tcp establish 3
!
crypto configuration

!
controller E1 0/2/0
framing NO-CRC4
line-termination 75-ohm
pri-group timeslots 1-31 service mgcp
!
!
interface FastEthernet0/0
ip address *.*.*.* *.*.*.*
speed 100
full-duplex
no cdp enable

h323-gateway voip bind srcaddr *.*.*.*
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
no cdp enable
!
interface Serial0/1/0
no ip address
shutdown
clock rate 2000000

no cdp enable
!
interface Serial0/2/0:15
no ip address
no ip proxy-arp
encapsulation hdlc
isdn switch-type primary-qsig
isdn overlap-receiving
isdn incoming-voice voice
isdn supp-service name calling

isdn bind-l3 ccm-manager
isdn negotiate-bchan
isdn bchan-number-order ascending
isdn sending-complete
no cdp enable
!
ip route 
0.0.0.0 0.0.0.0
 *.*.*.*
!
!
ip http server
ip http secure-server
!
logging *.*.*.*
access-list 1 permit *.*.*.*
access-list 1 permit *.*.*.*
dialer-list 1 protocol ip permit
snmp-server community voip RW 1

snmp-server community ext0399 RW 1
snmp-server community sw0399 RW 1
disable-eadi
no cdp run
!
control-plane
!
voice-port 0/2/0:15
!
ccm-manager mgcp
ccm-manager music-on-hold
ccm-manager config server *.*.*.*

ccm-manager config
!
mgcp
mgcp call-agent *.*.*.* 2427 service-type mgcp version 0.1
mgcp dtmf-relay voip codec all mode out-of-band
mgcp rtp unreachable timeout 1000 action notify
mgcp modem passthrough voip mode nse

mgcp package-capability rtp-package
no mgcp package-capability res-package
mgcp package-capability sst-package
no mgcp package-capability fxr-package
mgcp package-capability pre-package
no mgcp timer receive-rtcp

mgcp sdp simple
mgcp fax t38 inhibit
mgcp rtp payload-type g726r16 static
!
mgcp profile default
!
!
dial-peer cor custom
!
!
!
dial-peer voice 1 pots
service mgcpapp
port 0/2/0:15

!
!
!
line con 0
exec-timeout 0 0
password 7 *****************
logging synchronous
login
line aux 0
exec-timeout 0 0
password 7 *****************
logging synchronous
login
line vty 0 4

exec-timeout 0 0
password 7 **************
logging synchronous
login
!
scheduler allocate 20000 1000
ntp clock-period 17180079
ntp server *.*.*.*
!
webvpn context Default_context
ssl authenticate verify all

!
no inservice
end

_______________________________________________
cisco-voip mailing list

cisco-voip at puck.nether.net

https://puck.nether.net/mailman/listinfo/cisco-voip

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net

https://puck.nether.net/mailman/listinfo/cisco-voip

-- 
Omar E.P.T
-----------------
Certified Networking Professionals make better Connections!

http://omarept.blogspot.com/

  Usysnet Corp
Open Source Solutions
www.usysnet.com.pe
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

____________________________________________________________________________________
Need Mail bonding?
Go to the Yahoo! Mail Q&A for great tips from Yahoo! Answers users.
http://answers.yahoo.com/dir/?link=list&sid=396546091
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070302/c4dc1d98/attachment-0001.html 