[cisco-voip] Outbound call routing

[Patrick Diener]

maybe you could start by debugging the communication between the GW
and the PBX, so you can see if the PBX is actually rejecting the call
setup.

if its a analog interface (fxs, fxo, did, e&m) or a digital interface
configured for CAS "debug vpm signal" should produce some readable
output.

if you are using a ISDN connection (BRI, PRI) than "debug isdn q931"
is a good place to start... but if it is really a ISDN connection than
the pause between access code an the other digits should not be an
issue...

On 3/13/07, James Williams <JWilliams at ci.carson-city.nv.us> wrote:
> > I've checked that; I'm not even getting them off the console port. It's not just the VoIP debugs, either; I can't
> > get _any_ debugs to show up, even something like 'debug ip routing' (which, since this is on a core router, should
> > spam me into oblivion) spits back nothing at all.
>
> Belay that... someone set  'no logging console.' Grr.
>
> Anyhow, what debug command should I use to see what's being sent to the router from CCM? I've tried the 'voip ccapi' branch, but don't see the outgoing number in the output.
>
> -James
>
>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>