[cisco-voip] Debug on Inter-Cluster Trunk

[Ryan Ratliff]

If you have a router you can throw in there instead of a 6608 you can  
see if any name shows up in a q931 debug.

-Ryan

On Mar 15, 2007, at 12:30 PM, Christopher M. Bomba wrote:

When an IP phone calls the PBX phone the PBX phone displays the caller
ID but the IP phone does not show who you reached.

When a PBX phone calls an IP phone both phones only show an extension  
no name.

This is the same on both clusters.


I would think that if the PBX is sending the name with the CLID I  
would see it if a PBX phone calls an IP phone.  This is just like an  
outside caller calling into the company over a PRI.  I will double  
check my settings in the gateways and trunk settings but I think the  
PBX is not sending the name with the CLID.

Thanks,

Chris


-----Original Message-----
From: Ryan Ratliff <rratliff at cisco.com>
Sent: Wed, March 14, 2007 4:33 pm
To: cbomba at s4nets.com
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Debug on Inter-Cluster Trunk

How about when a PBX phone calls a phone on cluster B? Do you get
name there?

-Ryan

On Mar 14, 2007, at 4:26 PM, Christopher M. Bomba wrote:

I have two CCM clusters.

Cluster A

Cluster B

They are connected via inter-cluster trunk.  Cluster B is also
connected to a PBX using a 6608 blade.

CCM A ---ICT--- CCM B ---6608--- PBX

When a phone from CCM A calls a PBX phone I get CLID and Name.  When
a PBX phone calls a phone on CCM A I only get CLID.  Is there a way
to run a debug on a trunk to see what is being sent from cluster to
cluster?

Thanks,

Chris

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip