[cisco-voip] How to send unconfigured DIDs to an auto-attendant?

[Carter, Bill]

yes, XXXX is the way to do it.

________________________________

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Vince Loschiavo
Sent: Wednesday, May 16, 2007 2:05 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] How to send unconfigured DIDs to an
auto-attendant?


CCM 5.X, Unity 4.2 Unified Messaging, MGCP Gateways,
 
How can I send unconfigured DID's to an auto-attendant.
 
The customer has a block of numbers (xxx) XXX-1000 through 2000.  But
only 200 of the DID's are in use.  Right now if someone dials a number
that is not in use, the caller gets a re-order tone (fast busy).  How
can I forward those (in bulk) to the Auto-Attendant without configuring
CTI Route points for each DID?
 
I suspect that a CTI Route Point with a number of "XXXX" should do the
trick, but I haven't tested.  
 
Has anyone done this before?
 
____________________________________________________________
Vincent Loschiavo
Senior Consultant
Datacorp
18503 Pines Blvd
Suite 212
Pembroke Pines, FL, 33029

"Cisco Advanced Unified Communications Partner"
Cell Phone:        786-282-1164
Office Phone:    305-594-6933
____________________________________________________________ 
 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070517/d0427e2e/attachment.html