[cisco-voip] Faxes and Modems on VG224 FXS ports?

[Erick Bergquist]

I've got fax and modems to work on a VG224 with SCCP.

Same rules apply as other gateway, but you may have to force
passthrough mode. Make sure the PSTN gateway is set to the same method
so both match up. I can't find the document at the moment, but back
when I worked on a clients problems I found a cisco doc that said the
Vg224 did not support relay. But once I entered the commands below for
each port and shut/no shut the ports the FAX's started working.

For each port (global command),

stcapp register capability 2/9 modem-passthrough

then,

voice service voip
 fax protocol pass-through g711ulaw
 modem passthrough nse codec g711ulaw


On Nov 12, 2007 11:55 PM, Jason Aarons (US) <jason.aarons at us.didata.com> wrote:
>
>
>
>
> I can't find anything stating faxes/modems  VG224 are support in 12.4T when
> configured as SCCP.
>
>
> ________________________________
>
>
>  Disclaimer: This e-mail communication and any attachments may contain
> confidential and privileged information and is for use by the designated
> addressee(s) named above only. If you are not the intended addressee, you
> are hereby notified that you have received this communication in error and
> that any use or reproduction of this email or its contents is strictly
> prohibited and may be unlawful. If you have received this communication in
> error, please notify us immediately by replying to this message and deleting
> it from your computer. Thank you.
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>