[cisco-voip] Mobility Voice Access not working

[Jason Wydra]

In regard to the applciation command where I tell the gateway to download
the "cmm" app, how do I know it's actually download? Or does the app just
run from the CallManager?


On 11/14/07, Jason Wydra <jasonwydra at gmail.com> wrote:
>
> Thanks Justin. I have the same configuration but when I call my access
> number it just goes fast busy. I set up everything in CCM just like it says
> in the documentation, still no luck. I'm thinking TAC case at this point.
>
> On 11/14/07, Justin Steinberg <jsteinberg at gmail.com> wrote:
> >
> > I setup MVA using h323 hairpinning and had no problems with it, in
> > fact, i was suprised at how easy it was.
> >
> > below is my ios config.  on the cm side, i setup a h323 gw and a route
> > pattern.
> >
> >
> > voice service voip
> > allow-connections h323 to h323
> >
> > application
> > service CMM http://172.31.24.25:8080/ccmivr/pages/IVRMainpage.vxml
> >
> > dial-peer voice 84625555 voip
> > service cmm
> > destination-pattern 84625555
> > session target ipv4:172.31.24.25
> > incoming called-number 84625555
> > dtmf-relay h245-alphanumeric
> > codec g711ulaw
> > no vad
> > !
> >
> >
> >
> > On Nov 14, 2007 9:40 PM, Jason Wydra <jasonwydra at gmail.com> wrote:
> > > CUCMBE 6.0(1)
> > > 2811 12.4(13r)T
> > >
> > > I can't seem to get mobile voice access working. I followed the
> > directions
> > > to a T but I still can't get the IVR portion to answer. I configured
> > the
> > > H323 gateway as shown below. I also added the dial-peers as shown in
> > the
> > > config guide. I still get a fast busy when I call the external access
> > DID
> > > from a cell phone. Q931 shows the call coming into the gateway but it
> > gives
> > > me an unallocated/unassigned number error. Is there a trick to get
> > this vxml
> > > application to trigger? Do I have to load something into flash in
> > order for
> > > it to work? All configs on the CallManager side are complete. Thanks!
> > >
> > > Step 3
> > >
> > >
> > > Load the VXML application from the Cisco Unified Communications
> > Manager
> > > server (Publisher).
> > >
> > > Sample configuration for IOS Version 12.3 (13) and later:
> > >
> > > •application service CCM
> > >
> > > •http://<Unified CM cluster Publisher IP
> > > Addr>:8080/ccmivr/pages/IVRMainpage.vxml
> > > _______________________________________________
> > > cisco-voip mailing list
> > > cisco-voip at puck.nether.net
> > > https://puck.nether.net/mailman/listinfo/cisco-voip
> > >
> >
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20071115/c188cf0c/attachment.html