[cisco-voip] H.323 disconnect issue
Fedorov, Konstantin
kfedor at amt.ru
Thu Sep 20 12:01:23 EDT 2007
Hello Dave.
Codec mismatch ??
But it will be better if you collect damp of this call.
-----------------------
Sincerely Yours,
Konstantin Fedorov
_____
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Dave Wolgast
Sent: Thursday, September 20, 2007 7:54 PM
To: Cisco VOIP Newsletter - puck.nether.net
Subject: [cisco-voip] H.323 disconnect issue
Hello,
I have a Polycom VSX8000 connecting with a skinny IP phone via
gatekeeper-controlled H.323 trunk (Gatekeeper is Polycom SE200 -- Not
IOS). Calls are connected successfully in both directions using our
4-digit dial plan. However, when the Polycom H.323 VSX endpoint is the
first to hang up the call, the skinny phone gets reorder tone rather
than disconnecting. The display on the IP phone continues to say
'connected.'
At first glance, it seems as if there is never a disconnect message sent
from the H.323 side of the call. (We are also experiencing a similar
issue with an H.323 IVR that is defined as an H.323 gateway).
Can anyone make any suggestions as to what is going on here, and how I
should proceed?
Thanks!
--
Dave Wolgast
Inergex, Inc.
Buffalo, New York
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070920/d68a372d/attachment.html
More information about the cisco-voip
mailing list