[cisco-voip] Music On Hold Problem

[Estes, Timothy]

I'm not a multicast expert, but try "ip pim sparse-dense-mode".

-----Original Message-----
From: Timothy Smith [mailto:timotsmith at gmail.com]
Sent: Monday, December 08, 2008 11:29 AM
To: Estes, Timothy
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Music On Hold Problem

Timothy,

Please advise me on the correct IP PIM statement that I should put there.

I appreciate your assistance.

Regards,
TS

On Mon, Dec 8, 2008 at 7:21 PM, Estes, Timothy
<TimothyEstes at spherion.com> wrote:
> I don't see an IP PIM statement on that Gig E port.
>
> -----Original Message-----
> From: Timothy Smith [mailto:timotsmith at gmail.com]
> Sent: Monday, December 08, 2008 11:14 AM
> To: Estes, Timothy
> Cc: cisco-voip at puck.nether.net
> Subject: Re: [cisco-voip] Music On Hold Problem
>
> Hi,
>
> They are on the same network though the router (the gateway) has 2
> IPs. Infact, i have
>
> interface GigabitEthernet0/1
>  ip address 192.168.1.2 255.255.255.0
>  ip nat inside
>  ip virtual-reassembly
>  duplex auto
>  speed auto
>  h323-gateway voip interface
>  h323-gateway voip bind srcaddr 192.168.1.2
>
> somewhere in the router config. The IP of the call manager is
> 192.168.1.101. What should I set the hops to?
>
> Regards,
> TS
>
> On Mon, Dec 8, 2008 at 7:06 PM, Estes, Timothy
> <TimothyEstes at spherion.com> wrote:
>> Is your GW more than 2 IP hops away from your CM? You have 2 hops max setup in the music_on_hold_server.gif screen.
>>
>>
>> Tim
>>
>> -----Original Message-----
>> From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Timothy Smith
>> Sent: Saturday, December 06, 2008 12:32 PM
>> To: cisco-voip at puck.nether.net
>> Subject: [cisco-voip] Music On Hold Problem
>>
>> Hi,
>>
>> I have a IPT setup comprising of a cisco call manager 5.1 and using a cisco 2821 router as an h323 gateway to the PSTN over an E1 line.
>> Everything works well save for Music on hold! I have Tone on hold instead both internal and external calls. Could someone please point me any directions or  some tutorial/guides that can help me overcome this problem?
>>
>> I have tried whatever I can but no success.  Attached are some of the screen shots on what I think is important for MOH to work.
>>
>> Thanks!
>> TS
>>
>