[cisco-voip] Valcom Paging

[Voice Noob]

No it is not DTMF digits. It is like a very muffled dialtone

On Tue, Dec 16, 2008 at 4:24 PM, Bill Talley <billt at aos5.com> wrote:

> When you say stutter tone, does it play it overhead or in the telephone. If
> overhead, are you dropping the appropriate digits on the route pattern, If
> not, you'll hear dtmf over the paging system, which in some cases can be
> confused for stutter tone.
>
> --------
> Sent from a mobile device with very tiny keys. Please excuse my typos.
>
> ------------------------------
> From: Voice Noob <voicenoob at gmail.com>
> Sent: Tuesday, December 16, 2008 5:18 PM
> To: Truelove_John <JTruelove at aetinc.com>
> Cc: cisco-voip at puck.nether.net <cisco-voip at puck.nether.net>
>
> Subject: Re: [cisco-voip] Valcom Paging
>
>   When I call I get the port to go off hook but it plays a stuttered tone.
>
>
> On Tue, Dec 16, 2008 at 3:48 PM, Truelove_John <JTruelove at aetinc.com>wrote:
>
>>  This is from memory.
>>
>>
>>
>> I just used 2 wires to FXO (middle of RJ11), sounds like you have that
>> part right.
>>
>> Didn't use control1, then connected to TIP/RING # 1.
>>
>>
>>
>> You will also need to get you SW settings correct.  I think it was SW1
>> that I had to change.
>>
>> If I remember correctly, something was backward from the way that I was
>> thinking and I had to change it.
>>
>>
>>
>> I called Valcom support and they were very helpful.
>>
>>
>>
>>
>>
>>
>>
>> *From:* cisco-voip-bounces at puck.nether.net [mailto:
>> cisco-voip-bounces at puck.nether.net] *On Behalf Of *Voice Noob
>> *Sent:* Tuesday, December 16, 2008 4:27 PM
>> *To:* Truelove_John
>> *Cc:* cisco-voip at puck.nether.net
>> *Subject:* Re: [cisco-voip] Valcom Paging
>>
>>
>>
>> Can anyone tell me how to wire this to the FXO? I think I have it correct
>> but it is not working. On the Valcom system I have Tip1 Ring1 Control1
>> Control1 . I have the tip and ring in the middle pair on the RJ-11 and the
>> control on the outside pair. I get a fast busy when I call to the system.
>>
>>
>>
>> On Thu, Dec 11, 2008 at 7:53 PM, Truelove_John <JTruelove at aetinc.com>
>> wrote:
>>
>> I have.  FXO to 2 Valcom 9963s.
>>
>> I have had the Valcom 9963 lock up a couple of times which stops paging.
>> Rebooting 9963 fixes the problems.
>> I put the Valcom 9963s and Valcom 2006A on a power strip to quickly power
>> cycle.
>>
>> We do a lot of paging 10,000+ pages per month on those units.
>>
>> No problems with disconnects.  I did have to adjust the gain on the FXO
>> ports
>> for volume out to the 9963s.
>>
>>
>>
>>
>>
>> -----Original Message-----
>> From: cisco-voip-bounces at puck.nether.net on behalf of Voice Noob
>> Sent: Thu 12/11/2008 4:22 PM
>> To: cisco-voip at puck.nether.net
>> Subject: [cisco-voip] Valcom Paging
>>
>> I have a customer that has a Valcom V-2924A with a Valcom V-9963 Digital
>> Feedback Eliminator
>>
>> What type of connection would I use on the router? FXS or FXO ? Has anyone
>> integrated with these? Are there any problems with disconnect or anything
>> else to watch out for. Thanks for your help.
>>
>>
>>
>>
>>
>>
>>
>
> CONFIDENTIALITY NOTICE: This electronic mail transmission (including any accompanying attachments) is intended solely for its authorized recipient(s), and may contain confidential and/or legally privileged information. If you are not an intended recipient, or responsible for delivering some or all of this transmission to an intended recipient, be aware that any review, copying, printing, distribution, use or disclosure of the contents of this message is strictly prohibited. If you have received this electronic mail message in error, please delete it from your system without copying it, and contact sender immediately by Reply e-mail, or by calling 913-307-2300, so that our address records can be corrected.
>
> Although this e-mail and any attachments are believed to be free of any virus or other defect that might negatively affect any computer system into which it is received and opened, it is the responsibility of the recipient to ensure that it is virus free and no responsibility is accepted by the sender for any loss or damage arising in any way in the event that such a virus or defect exists.
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20081216/72e0d19f/attachment.html>