[cisco-voip] Valcom Paging

Tue Dec 16 18:46:03 EST 2008

I just looked at our 9964.

SW1       pushed to the right

SW2       pushed to the right

SW3       U D D D D D D D

SW4       D D D D D D D U

Those are our settings.  It does an alert tone before accepting the
page.

Hope that helps.

John

From: Bill Talley [mailto:billt at aos5.com] 
Sent: Tuesday, December 16, 2008 6:08 PM
To: Voice Noob
Cc: Truelove_John; cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] Valcom Paging

In that case I believe there's a dip switch setting that enables or
disables an alert tone. I apologize for not knowing off hand what the
correct setting is but at least wanted to let you know it was there.
It's probably the same switch, or next to the switch John was referring
to in his earlier email.

--------
Sent from a mobile device with very tiny keys. Please excuse my typos.

________________________________

From: Voice Noob <voicenoob at gmail.com>
Sent: Tuesday, December 16, 2008 5:26 PM
To: Bill Talley <billt at aos5.com>
Cc: Truelove_John <JTruelove at aetinc.com>; cisco-voip at puck.nether.net
<cisco-voip at puck.nether.net>
Subject: Re: [cisco-voip] Valcom Paging

No it is not DTMF digits. It is like a very muffled dialtone

On Tue, Dec 16, 2008 at 4:24 PM, Bill Talley <billt at aos5.com> wrote:

When you say stutter tone, does it play it overhead or in the telephone.
If overhead, are you dropping the appropriate digits on the route
pattern, If not, you'll hear dtmf over the paging system, which in some
cases can be confused for stutter tone. 

--------
Sent from a mobile device with very tiny keys. Please excuse my typos.

________________________________

From: Voice Noob <voicenoob at gmail.com>
Sent: Tuesday, December 16, 2008 5:18 PM
To: Truelove_John <JTruelove at aetinc.com>
Cc: cisco-voip at puck.nether.net <cisco-voip at puck.nether.net> 

Subject: Re: [cisco-voip] Valcom Paging

When I call I get the port to go off hook but it plays a stuttered tone.

On Tue, Dec 16, 2008 at 3:48 PM, Truelove_John <JTruelove at aetinc.com>
wrote:

This is from memory.

I just used 2 wires to FXO (middle of RJ11), sounds like you have that
part right.

Didn't use control1, then connected to TIP/RING # 1.

You will also need to get you SW settings correct.  I think it was SW1
that I had to change.

If I remember correctly, something was backward from the way that I was
thinking and I had to change it.

I called Valcom support and they were very helpful.

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Voice Noob
Sent: Tuesday, December 16, 2008 4:27 PM
To: Truelove_John
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Valcom Paging

Can anyone tell me how to wire this to the FXO? I think I have it
correct but it is not working. On the Valcom system I have Tip1 Ring1
Control1 Control1 . I have the tip and ring in the middle pair on the
RJ-11 and the control on the outside pair. I get a fast busy when I call
to the system. 

On Thu, Dec 11, 2008 at 7:53 PM, Truelove_John <JTruelove at aetinc.com>
wrote:

I have.  FXO to 2 Valcom 9963s.

I have had the Valcom 9963 lock up a couple of times which stops paging.
Rebooting 9963 fixes the problems.
I put the Valcom 9963s and Valcom 2006A on a power strip to quickly
power cycle.

We do a lot of paging 10,000+ pages per month on those units.

No problems with disconnects.  I did have to adjust the gain on the FXO
ports
for volume out to the 9963s. 

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net on behalf of Voice Noob
Sent: Thu 12/11/2008 4:22 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] Valcom Paging

I have a customer that has a Valcom V-2924A with a Valcom V-9963 Digital
Feedback Eliminator

What type of connection would I use on the router? FXS or FXO ? Has
anyone
integrated with these? Are there any problems with disconnect or
anything
else to watch out for. Thanks for your help.

CONFIDENTIALITY NOTICE: This electronic mail transmission (including any
accompanying attachments) is intended solely for its authorized
recipient(s), and may contain confidential and/or legally privileged
information. If you are not an intended recipient, or responsible for
delivering some or all of this transmission to an intended recipient, be
aware that any review, copying, printing, distribution, use or
disclosure of the contents of this message is strictly prohibited. If
you have received this electronic mail message in error, please delete
it from your system without copying it, and contact sender immediately
by Reply e-mail, or by calling 913-307-2300, so that our address records
can be corrected.

Although this e-mail and any attachments are believed to be free of any
virus or other defect that might negatively affect any computer system
into which it is received and opened, it is the responsibility of the
recipient to ensure that it is virus free and no responsibility is
accepted by the sender for any loss or damage arising in any way in the
event that such a virus or defect exists.

CONFIDENTIALITY NOTICE: This electronic mail transmission (including any
accompanying attachments) is intended solely for its authorized
recipient(s), and may contain confidential and/or legally privileged
information. If you are not an intended recipient, or responsible for
delivering some or all of this transmission to an intended recipient, be
aware that any review, copying, printing, distribution, use or
disclosure of the contents of this message is strictly prohibited. If
you have received this electronic mail message in error, please delete
it from your system without copying it, and contact sender immediately
by Reply e-mail, or by calling 913-307-2300, so that our address records
can be corrected.

Although this e-mail and any attachments are believed to be free of any
virus or other defect that might negatively affect any computer system
into which it is received and opened, it is the responsibility of the
recipient to ensure that it is virus free and no responsibility is
accepted by the sender for any loss or damage arising in any way in the
event that such a virus or defect exists.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20081216/1960686f/attachment.html>