[cisco-voip] Can you prevent the phone phone display from showing the translated number?

[Patrick Mowry]

Close enough.  The Calling phone says "To Private" instead of showing the *50 or the translated number.  Thanks for the quick response,

-Patrick


-----Original Message-----
From: Keith Klevenski [mailto:keith.klevenski at rig.net]
Sent: Fri 2/15/2008 2:19 PM
To: Patrick Mowry; cisco-voip at puck.nether.net
Subject: RE: Can you prevent  the phone phone display from showing the translated number?
 
At least in 4.x I believe it is the Connected Line ID Presentation on the route pattern/translation pattern.  Set to restricted to not display the connected party's number.

Keith Klevenski
Senior IP Telephony Engineer
RigNet Inc.
1880 S. Dairy Ashford
Suite 300
Houston, TX 77077         
Office:   +1 281.674.0702
Mobile:  +1 713.677.3925
http://www.rig.net

"Always Connected"

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Patrick Mowry
Sent: Friday, February 15, 2008 2:14 PM
To: cisco-voip at puck.nether.net
Subject: Can you prevent the phone phone display from showing the translated number?


 I want a code someone would dial( say *50) that would be translated to my cellphone number and sent to the gateway.  But I want the display for the called number on the phone to say *50 and not 3375551212.  Can this be done in CUCM6.1 with MGCP gateways?

thanks for the help, -Patrick