[cisco-voip] different SRST alias for different phones

[Patrick Diener]

I used this in a CME environment where the customer gradually added
phones and extensions.
The customer wanted that all calls to yet unallocated numbers are
routed to a certain extension.
This little configuration did the trick quite nicely... it's like a
Translation Pattern in CallManager!


On Thu, Feb 28, 2008 at 9:09 PM, Lelio Fulgenzi <lelio at uoguelph.ca> wrote:
> OK, so it's not using a PRI channel or anything, it's just IP in and out
>  since it's a voip dialpeer. I like that. I'll have to remember that. I think
>  it will be an effective way to route calls from different sets of phones to
>  different targets but using the same number, i.e. 0.
>
>
>  Lelio
>  --------------------------------------------------------------------------------
>  Lelio Fulgenzi, B.A.
>  Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
>  (519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
>  ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
>  "Buffalo buffalo Buffalo buffalo buffalo buffalo Buffalo buffalo."      WJR
>
>  ----- Original Message -----
>  From: "Patrick Diener" <patrick.diener at gmail.com>
>  To: "Lelio Fulgenzi" <lelio at uoguelph.ca>; <cisco-voip at puck.nether.net>
>
>
> Sent: Thursday, February 28, 2008 2:40 PM
>  Subject: Re: [cisco-voip] different SRST alias for different phones
>
>
>  > jepp, (if its called a "trunk" in IOS call routing slang...)
>  >
>  > dial-peer voice 10 voip
>  > destination-pattern <some_number>
>  > session target ipv4:<srst_router_ip>
>  > translation-profile outgoing <some_profile>
>  > cor outgoing <some_cor_list>
>  >
>  > so a call to <some_number> will hit dial-peer 10, the defined
>  > translation is executed, the call "leaves" the router and immediately
>  > comes back.
>  >
>  >
>  > On Thu, Feb 28, 2008 at 7:50 PM, Lelio Fulgenzi <lelio at uoguelph.ca> wrote:
>  >> you mean go in and out of a trunk?
>  >>
>  >>
>  >>  Lelio
>  >>  --------------------------------------------------------------------------------
>  >>  Lelio Fulgenzi, B.A.
>  >>  Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
>  >>  (519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
>  >>  ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
>  >>  "Buffalo buffalo Buffalo buffalo buffalo buffalo Buffalo buffalo."
>  >> WJR
>  >>
>  >>  ----- Original Message -----
>  >>  From: "Patrick Diener" <patrick.diener at gmail.com>
>  >>
>  >>
>  >> To: "Lelio Fulgenzi" <lelio at uoguelph.ca>; <cisco-voip at puck.nether.net>
>  >>  Sent: Thursday, February 28, 2008 11:47 AM
>  >>  Subject: Re: [cisco-voip] different SRST alias for different phones
>  >>
>  >>
>  >>  > ahh you dont want to dial out to the PSTN just use alias to convert
>  >> some
>  >>  > numbers
>  >>  >
>  >>  > if you need CoR to control which 0 is converted to which number (afaik
>  >>  > thats no possible using num-exp) you could use voip dial-peers and
>  >>  > make voip hairpin calls...
>  >>  >
>  >>  > On Thu, Feb 28, 2008 at 5:11 PM, Lelio Fulgenzi <lelio at uoguelph.ca>
>  >> wrote:
>  >>  >> I was thinking that, but then I have to supply a port for the
>  >> dial-peer
>  >>  >> to
>  >>  >>  work or be "up". Wouldn't I?
>  >>  >>
>  >>  >>
>  >>  >>  Lelio
>  >>
>  >>  >>  --------------------------------------------------------------------------------
>  >>  >>  Lelio Fulgenzi, B.A.
>  >>  >>  Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G
>  >> 2W1
>  >>  >>  (519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
>  >>  >>
>  >> ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
>  >>  >>  "Buffalo buffalo Buffalo buffalo buffalo buffalo Buffalo buffalo."
>  >>  >> WJR
>  >>  >>
>  >>  >>
>  >>  >>
>  >>  >> ----- Original Message -----
>  >>  >>  From: "Patrick Diener" <patrick.diener at gmail.com>
>  >>  >>  To: "Lelio Fulgenzi" <lelio at uoguelph.ca>
>  >>  >>  Cc: <cisco-voip at puck.nether.net>
>  >>  >>  Sent: Thursday, February 28, 2008 11:08 AM
>  >>  >>  Subject: Re: [cisco-voip] different SRST alias for different phones
>  >>  >>
>  >>  >>
>  >>  >>  > nope, access to alias is not controlled by CoR
>  >>  >>  >
>  >>  >>  > but you could create several dial-peers with destination-pattern 0
>  >> and
>  >>  >>  > use voice translation-rules to change the called party number to
>  >> the
>  >>  >>  > desired value...
>  >>  >>  >
>  >>  >>  > Regards
>  >>  >>  > Patrick
>  >>  >>  >
>  >>  >>  > On Thu, Feb 28, 2008 at 4:50 PM, Lelio Fulgenzi
>  >> <lelio at uoguelph.ca>
>  >>  >> wrote:
>  >>  >>  >>
>  >>  >>  >>
>  >>  >>  >> I'd like 0 to go to different destinations when in SRST mode. Can
>  >> I
>  >>  >> set
>  >>  >>  >> up a
>  >>  >>  >> different alias depending on COR lists?
>  >>  >>  >>
>  >>  >>  >> Lelio
>  >>  >>
>  >>  >> --------------------------------------------------------------------------------
>  >>  >>  >> Lelio Fulgenzi, B.A.
>  >>  >>  >> Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G
>  >> 2W1
>  >>  >>  >> (519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
>  >>  >>  >>
>  >>  >>
>  >> ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
>  >>  >>  >> "Buffalo buffalo Buffalo buffalo buffalo buffalo Buffalo
>  >> buffalo."
>  >>  >>  >> WJR
>  >>  >>  >>
>  >>  >>  >> _______________________________________________
>  >>  >>  >>  cisco-voip mailing list
>  >>  >>  >>  cisco-voip at puck.nether.net
>  >>  >>  >>  https://puck.nether.net/mailman/listinfo/cisco-voip
>  >>  >>  >>
>  >>  >>  >>
>  >>  >>  >
>  >>  >>
>  >>  >>
>  >>  >
>  >>
>  >>
>  >
>
>