[cisco-voip] Cisco 3825 As RAS: Modem Connection Issue
Ramiz Sardar
ramizchaudhary at gmail.com
Fri Feb 29 04:56:27 EST 2008
Friends,
I configured 3825 router as RAS but not working. You can find the sh
running, show version and debug isdn q931 outputs.
Hardware: 3825, NM-HDV2-2T1/E1, pvdm2-64, NM-30DM
Topology:
RAS------(PRI)------PBX----------Dialup User
Configuration:
++++++++++++++ Show Running ++++++++++++++++++
RAS#sh run
Building configuration...
Current configuration : 2613 bytes
!
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname RAS
!
boot-start-marker
boot-end-marker
!
card type e1 0 0
card type e1 2 1
enable password cisco
!
aaa new-model
!
!
aaa authentication login abc local
!
!
aaa session-id common
no network-clock-participate slot 2
no network-clock-participate wic 0
ip cef
!
multilink virtual-template 1
multilink bundle-name authenticated
!
isdn switch-type primary-qsig
isdn voice-call-failure 0
voice-card 0
no dspfarm
!
voice-card 2
no dspfarm
!
!
username admin password 0 cisco
!
!
controller E1 0/0/0
channel-group 0 timeslots 1-31
!
controller E1 0/0/1
!
controller E1 2/0
pri-group timeslots 1-31
!
controller E1 2/1
vlan internal allocation policy ascending
!
!
interface Loopback0
ip address 10.10.10.1 255.255.255.255
!
interface GigabitEthernet0/0
no ip address
shutdown
duplex auto
speed auto
media-type rj45
no keepalive
!
interface GigabitEthernet0/1
no ip address
shutdown
duplex auto
speed auto
media-type rj45
no keepalive
!
interface Serial0/0/0:0
no ip address
!
interface Serial2/0:15
ip unnumbered Loopback0
encapsulation ppp
dialer idle-timeout 2147483
dialer-group 1
isdn switch-type primary-qsig
isdn timer T310 120000
isdn protocol-emulate network
isdn incoming-voice modem
no fair-queue
ppp authentication pap
ppp multilink
!
interface Virtual-Template1
description Multilink for Async Users
ip unnumbered Loopback0
timeout absolute 5400 0
peer default ip address pool dialpool
ppp authentication pap
ppp multilink
ppp multilink fragment disable
!
interface Dialer1
ip unnumbered Loopback0
encapsulation ppp
no ip mroute-cache
dialer in-band
dialer idle-timeout 0
dialer-group 1
peer default ip address pool dialpool
no fair-queue
no cdp enable
ppp authentication pap callin
ppp multilink
!
interface Group-Async0
no ip address
encapsulation ppp
no snmp trap link-status
async dynamic address
async mode dedicated
peer default ip address pool dialpool
no fair-queue
ppp max-bad-auth 3
ppp authentication pap
ppp multilink
group-range 1/0 1/29
!
ip local pool dialpool 10.10.10.10 10.10.10.40
!
!
ip http server
no ip http secure-server
!
!
!
control-plane
!
!
!
voice-port 2/0:15
!
line con 0
stopbits 1
line aux 0
line 1/0 1/29
exec-timeout 0 0
no flush-at-activation
modem Dialin
modem autoconfigure type si3
transport input all
autoselect during-login
autoselect ppp
line vty 0 4
!
scheduler allocate 20000 1000
!
end
+++++++++++++ Sh Verion ++++++++++++++
RAS#sh ver
Cisco IOS Software, 3800 Software (C3825-ADVENTERPRISEK9-M), Version
12.4(11)XJ4, RELEASE SOFTWARE (fc2)
ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
RAS uptime is 26 minutes
System returned to ROM by reload at 12:40:18 UTC Thu Feb 28 2008
System image file is "flash:c3825-adventerprisek9-mz.124-11.XJ4.bin"
Cisco 3825 (revision 1.1) with 221184K/40960K bytes of memory.
Processor board ID FCZ11057005
2 Gigabit Ethernet interfaces
33 Serial interfaces
30 terminal lines
4 Channelized E1/PRI ports
2 Virtual Private Network (VPN) Modules
DRAM configuration is 64 bits wide with parity enabled.
479K bytes of NVRAM.
62720K bytes of ATA System CompactFlash (Read/Write)
Configuration register is 0x2102
RAS#
++++++++++++++ Debug ISDN Q931 +++++++++++++++
RAS#
*Feb 28 13:08:45.891: ISDN Se2/0:15 Q931: RX <- SETUP pd = 8 callref =
0x2CD6
Bearer Capability i = 0x8090A3
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA18396
Preferred, Channel 22
Facility i =
0x9FAA068001008201008B0100A1100201010201008008545247524F4F4D20
Progress Ind i = 0x8183 - Origination address is non-ISDN
Calling Party Number i = 0x0181, '35240'
Plan:ISDN, Type:Unknown
Called Party Number i = 0x81, '8701'
Plan:ISDN, Type:Unknown
Shift to Codeset 5
Codeset 5 IE 0x31 i = 0x80
Shift to Codeset 5
Codeset 5 IE 0x32 i = 0x81
*Feb 28 13:08:45.891: %CSM-1-NO_CHANNEL: Signaling channel not available
*Feb 28 13:08:45.891: ISDN Se2/0:15 **ERROR**: accept_incoming_csm_call:
modem problem Requested circuit/channel not available(0x2C): b channel 21,
call id 0x6
*Feb 28 13:08:45.895: ISDN Se2/0:15 Q931: TX -> CALL_PROC pd =
8 callref = 0xACD6
Channel ID i = 0xA98396
Exclusive, Channel 22
*Feb 28 13:08:45.895: ISDN Se2/0:15 Q931: TX -> DISCONNECT pd =
8 callref = 0xACD6
Cause i = 0x82AC - Requested circuit/channel not available
*Feb 28 13:08:45.983: ISDN Se2/0:15 Q931: RX <- RELEASE pd = 8 callref
= 0x2CD6
Cause i = 0x81AC - Requested circuit/channel not available
*Feb 28 13:08:45.983: ISDN Se2/0:15 Q931: TX -> RELEASE_COMP pd =
8 callref = 0xACD6
*Feb 28 13:08:46.059: ISDN Se2/0:15 Q931: RX <- SETUP pd = 8 callref =
0x2CD7
Bearer Capability i = 0x8090A3
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA18397
Preferred, Channel 23
Facility i =
0x9FAA068001008201008B0100A1100201010201008008545247524F4F4D20
Progress Ind i = 0x8183 - Origination address is non-ISDN
Calling Party Number i = 0x0181, '35240'
Plan:ISDN, Type:Unknown
Called Party Number i = 0x81, '8701'
Plan:ISDN, Type:Unknown
Shift to Codeset 5
Codeset 5 IE 0x31 i = 0x80
Shift to Codeset 5
Codeset 5 IE 0x32 i = 0x81
*Feb 28 13:08:46.059: *%CSM-1-NO_CHANNEL: Signaling channel not
available*
*Feb 28 13:08:46.059: *ISDN Se2/0:15 **ERROR**:
accept_incoming_csm_call: modem problem Requested circuit/channel not
available(0x2C): b channel 22, call id 0x7*
*Feb 28 13:08:46.059: ISDN Se2/0:15 Q931: TX -> CALL_PROC pd =
8 callref = 0xACD7
Channel ID i = 0xA98397
Exclusive, Channel 23
*Feb 28 13:08:46.059: ISDN Se2/0:15 Q931: TX -> DISCONNECT pd =
8 callref = 0xACD7
Cause i = 0x82AC - Requested circuit/channel not available
*Feb 28 13:08:46.163: ISDN Se2/0:15 Q931: RX <- RELEASE pd = 8 callref
= 0x2CD7
Cause i = 0x81AC - Requested circuit/channel not available
*Feb 28 13:08:46.163: ISDN Se2/0:15 Q931: TX -> RELEASE_COMP pd =
8 callref = 0xACD7
RAS#
Please help me get this issue resolved.
Regards
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20080229/7ce36794/attachment-0001.html
More information about the cisco-voip
mailing list