[cisco-voip] getting state from isdn line (idle-occupied)

[daniel.abelski at gmail.com]

Using ISDN PRI to connect to HPath - IMO no. The only way its usually
done - is via Q.SIG but it works when interconnecting single vendor
PBX systems.

You can find a way to do this using SIP here
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmepres.html
but don`t know if your HPath can by used for it.


On 1/17/08, Konne <bridge_stone at gmx.net> wrote:
> hi,
>
> ive running a Router 2811 ccme4.1 with cisco voip phones 7961G,
> connected to a Siemens HiPath 3550 with ISDN Phones. Is it possible to
> Get the state of a line from the siemens. i mean, if the ISDN Number 700
> is occupied/idle i will see it on my Cisco 7961G phone as occupied/idle
> (led red/green/orange)
>
> or is it impossible.
>
> thx
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>


-- 
Regards,                    |        С Уважением,
Daniel A. Abelski        |        Абельский Даниил Александрович