[cisco-voip] selectively pick a BRI or PRI from different extensions behind call manager

[Erik Erasmus (E)]

Does anyone have experience in selecting a specific ISDN basic rate or
primary rate line on a voice gateway from a call manager and what
would be the best way to do it.

 

I have a solution where two businesses will share a gateway and they
will each have a separate BRI to keep pstn billing separate - they
share a call manager. How would one make a specific range of
extensions always pick one BRI when dialing out to pstn and another
range select another BRI on the same gateway preferably. 

 

If possible I want to use a single gateway 

With two gateways I guess it would be a lot easier - possible using
different pstn access codes and then selecting different route
patterns / rlists/ routegroups / gateway  

 

I am not too fussy about h323 versus mgcp - but have more h323
experience so will probably prefer this 

 

 

Any advice will be appreciated

 

 

 

Erik Erasmus

\



~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This e-mail is subject to the Telkom SA electronic communication legal notice, available at :
http://www.telkom.co.za/TelkomEMailLegalNotice.PDF
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20080129/a470bf37/attachment.html