[cisco-voip] ISDN PRI channel stuck in busy status?
Jason Aarons (US)
jason.aarons at us.didata.com
Fri Jul 18 14:46:04 EDT 2008
I would replace the DSPs.
-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of
keli at carocomp.ro
Sent: Friday, July 18, 2008 2:28 PM
To: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] ISDN PRI channel stuck in busy status?
Any ideas on this?
The ten channels seem to "fill up" with busy channels after about half
a day or so of normal call traffic (2-3 simultaneous calls usually).
thanks,
Zoltan
Quoting Kelemen Zoltan <keli at carocomp.ro>:
> Hi!
>
> We have a CCME, 4.2(0), IOS: 12.4(11)XW6 with a partial E1.
>
> When examining some complaints, that the client was unable to place
> more than a few calls outside and most of incoming calls failed to
> reach them, I found the ISDN interface with more busy channels than
> active voice calls.
>
> Below I attached an example, where channel 9 is stuck (on channel 10 I
> might have just catched a call that just disconnected, but channel 9
> was continuously stuck busy with no active call on it.).
>
> This is relatively light, since there's still 9 other channels for
> light traffic, but I have seen this interface with 8 or even all ten
> channels stuck. So far I haven't found any other way to solve it
but
> to restart the serial interface.
>
> Any ideas what could be going wrong? Or at least if it's possible to
> recover a channel from that state, other than restarting the
interface?
>
> Thanks,
> Zoltan
>
>
> ccme#sh isdn stat ser 0/0/0:15
> Global ISDN Switchtype = primary-net5
> ISDN Serial0/0/0:15 interface
> dsl 0, interface ISDN Switchtype = primary-net5
> Layer 1 Status:
> ACTIVE
> Layer 2 Status:
> TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
> Layer 3 Status:
> 1 Active Layer 3 Call(s)
> CCB:callid=2707, sapi=0, ces=0, B-chan=9, calltype=VOICE
> CCB:callid=A622, sapi=0, ces=0, B-chan=8, calltype=VOICE
> CCB:callid=A627, sapi=0, ces=0, B-chan=10, calltype=VOICE
> CCB:callid=270E, sapi=0, ces=0, B-chan=7, calltype=VOICE
> Active dsl 0 CCBs = 4
> The Free Channel Mask: 0x8000003F
> Number of L2 Discards = 0, L2 Session ID = 113
>
>
> ccme#sh isdn serv ser 0/0/0:15
> PRI Channel Statistics:
> ISDN Se0/0/0:15, Channel [1-31]
> Configured Isdn Interface (dsl) 0
> Channel State (0=Idle 1=Proposed 2=Busy 3=Reserved 4=Restart
5=Maint_Pend)
> Channel : 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8
9 0 1
> State : 0 0 0 0 0 0 2 2 2 2 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3
3 3 3
> Service State (0=Inservice 1=Maint 2=Outofservice 8=MaintPend
9=OOSPend)
> Channel : 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8
9 0 1
> State : 0 0 0 0 0 0 0 0 0 0 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
2 2 2
>
>
>
> ccme#sh voice call 0/0/0:15 0/0/0:15 1 - - -
> 0/0/0:15 2 - - - 0/0/0:15 3 -
> - - 0/0/0:15 4 - - -
> 0/0/0:15 5 - - - 0/0/0:15 6 - -
> - 0/0/0:15 7
> vtsp level 0 state = S_CONNECT
> callid 0x270E B07 state S_TSP_CONNECT clld 100 cllg 7518XXXXX
> 0/0/0:15 8
> vtsp level 0 state = S_CONNECT
> callid 0xA622 B08 state S_TSP_CONNECT clld 07499XXXXX cllg 113
> 0/0/0:15 9 - - - 0/0/0:15 10- -
> - -------------------------------- configuration
>
> controller E1 0/0/0
> framing NO-CRC4
> clock source internal
> pri-group timeslots 1-10,16
> !
> interface Serial0/0/0:15
> no ip address
> encapsulation hdlc
> isdn switch-type primary-net5
> isdn overlap-receiving
> isdn incoming-voice voice
> isdn send-alerting
> isdn sending-complete
> no cdp enable
> !
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
-----------------------------------------
Disclaimer:
This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the
designated addressee(s) named above only. If you are not the
intended addressee, you are hereby notified that you have received
this communication in error and that any use or reproduction of
this email or its contents is strictly prohibited and may be
unlawful. If you have received this communication in error, please
notify us immediately by replying to this message and deleting it
from your computer. Thank you.
More information about the cisco-voip
mailing list