[cisco-voip] did/fxs config help

[Dan Letkeman]

Ok.  I think I need to configure both the dial peer's and the
called-number.  Do you have an example config or some links to
configure this?

Thanks,
Dan.

On Wed, Jul 23, 2008 at 6:46 AM, Craig Staffin <craig at staffin.org> wrote:
> Moataz,
> Not always true the FXS ports are actually used for analog DID trunks.
> As far as the problem do you have dial peers on the router?  You will need
> both an inacoming dial peer and outgoing OR  a phone with that DN on it
> THe incoming must have incoming-called-number . (or some form of the number)
> Craig
>
> On Wed, Jul 23, 2008 at 4:43 AM, Moataz Mamdouh <moataz_mmdh at yahoo.com>
> wrote:
>>
>> u call from FXS!!!!
>> --- On Tue, 7/22/08, Dan Letkeman <danletkeman at gmail.com> wrote:
>>
>> From: Dan Letkeman <danletkeman at gmail.com>
>> Subject: [cisco-voip] did/fxs config help
>> To: cisco-voip at puck.nether.net
>> Date: Tuesday, July 22, 2008, 9:51 PM
>>
>> Hello,
>>
>> I'm trying to setup a couple of did lines into a cme router.
>> Currently the voice ports look like this:
>>
>> voice-port 0/1/1
>>  signal did wink-start
>>
>>  input gain 4
>>
>> and I have setup the num-exp commands:
>>
>> num-exp 2346 1002
>> num-exp 2341 1011
>> num-exp 2347 1020
>>
>> I'm guessing I need a dial-peer?
>>
>> When I call the number 5552340 all I get is a busy signal.
>>
>>
>> Where should I go from
>>  here?
>>
>> Thanks,
>> Dan.
>> _______________________________________________
>> cisco-voip mailing list
>> cisco-voip at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>
>> _______________________________________________
>> cisco-voip mailing list
>> cisco-voip at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>
>
>
>
> --
> Craig Staffin
> Craig at staffin.org
> (H) 262-437-7313
> (C) 262-613-6003