[cisco-voip] Volume 1 -- Section 6 (Dial Plan) question

[Bill Talley]

Yeah, um... I was wrong.  Thanks for the clarification Lelio!

*** Sent from a mobile device with very tiny keys.  Please excuse my typos. ***

-----Original Message-----
From: Michael Thompson <mthompson729 at gmail.com>
Sent: Thursday, July 31, 2008 9:33 PM
To: 'Lelio Fulgenzi' <lelio at uoguelph.ca>; 'VoIP' <cisco-voip at puck.nether.net>
Subject: Re: [cisco-voip] Volume 1 -- Section 6 (Dial Plan) question

That makes more sense, thank you!

So essentially what that comment is stating is to make sure we have a dial
peer like:

Dial-peer 1 voice pots

Direct-inward-dial

Incoming called-number .

Port blah blah blah

 

 

 

 

  _____  

From: Lelio Fulgenzi [mailto:lelio at uoguelph.ca] 
Sent: Thursday, July 31, 2008 10:26 PM
To: Michael Thompson; 'VoIP'
Subject: Re: [cisco-voip] Volume 1 -- Section 6 (Dial Plan) question

 

two stage dialing is when you dial a number assigned to one of your
trunks/lines attached to your router and it gives you a local dialtone. from
there you can dial any of the dialpeers that inbound trunk has access too.

 

i believe it's biggest use is for those LD resellers. you can add a TCL
script app to the system to check for PINs and balance owing etc.

 

by doing something line DID . <- notice the DOT, it sends the DID to the
system for interpretation. or something like that.

 

----------------------------------------------------------------------------
----
Lelio Fulgenzi, B.A.
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 
"Bad grammar makes me [sic]" - Tshirt

----- Original Message ----- 

From: Michael <mailto:mthompson729 at gmail.com>  Thompson 

To: 'VoIP' <mailto:cisco-voip at puck.nether.net>  

Sent: Thursday, July 31, 2008 10:07 PM

Subject: [cisco-voip] Volume 1 -- Section 6 (Dial Plan) question

 

I'm going through and reviewing some of the material and there's a specific
comment that I'm stuck on.  Task 6.6, it states:

 

Enable DID for PSTN users dialing into CM/UCME (.i.e. 2-stage dialing must
not be used).  

 

I don't understand what they're referring to by 2-stage dialing.

 

Are they just looking for something as simple as the direct-inward-dial on
CME and making sure we're sending 4 significant digits on the Trunks of UC?

 

MT

 

 

 


  _____  


_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip




CONFIDENTIALITY NOTICE: This electronic mail transmission (including any accompanying attachments) is intended solely for its authorized recipient(s), and may contain confidential and/or legally privileged information. If you are not an intended recipient, or responsible for delivering some or all of this transmission to an intended recipient, be aware that any review, copying, printing, distribution, use or disclosure of the contents of this message is strictly prohibited. If you have received this electronic mail message in error, please delete it from your system without copying it, and contact sender immediately by Reply e-mail, or by calling 913-307-2300, so that our address records can be corrected.

Although this e-mail and any attachments are believed to be free of any virus or other defect that might negatively affect any computer system into which it is received and opened, it is the responsibility of the recipient to ensure that it is virus free and no responsibility is accepted by the sender for any loss or damage arising in any way in the event that such a virus or defect exists.