[cisco-voip] Function for the Voice Comamnd

[Michael Thompson]

Section A creates a template of H.323 commands (H.2X5 setup timers, etc) and
Codecs (G.711, G.729, etc) to be applied to dial peers.  It saves you the
time of having to create those same commands on each and every dial peer
(and minimizes the changes that are needed if you need to tweak).

 

Section B is configuring IP to IP Gateway (now known as a Border Element).
It allows for IP to IP calls (as the name suggest) versus a standard gateway
that normally creates IP to PSTN connections.  It's going to be
over-simplistic, but each IP call has 2 call legs.  In a standard gateway
config, the call would connect from a POTS port to a VoIP (MMoIP, etc) leg.
In the IP to IP Gateway config, it allows for IP to IP calls.

 

  _____  

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of davidytk
Sent: Tuesday, November 04, 2008 10:22 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] Function for the Voice Comamnd

 

Hi All

 

i have some command , do you know the function on this

 

a.      voice-class h323

          voice-class codec 1 

under dial-peer voice xxx voip

 

 

b.      voice service voip

          allow-connection h323 to h323

allow-connection sip to sip

 

 

I don't know what these command used for ? Can you explain on this

 

Thanks

 

Best Regards

David

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20081104/1acaaaa8/attachment.html>