[cisco-voip] T1-CAS E&M and Callerid

[Carter, Bill]

That was my request/suggestion to the customer.

****This message was sent from my Nokia E61i****

-----Original Message-----
From: Jason Aarons (US)
Sent: Tue 09/02/2008 7:16 PM
To: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] T1-CAS E&M and Callerid

I would have them asking telco if they can swap to a
PRI.....troubleshooting is much easier

 

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jonathan
Charles
Sent: Tuesday, September 02, 2008 5:14 PM
To: Kris Seraphine
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] T1-CAS E&M and Callerid

 

Or, another way...

Split the DS0 groups as described, but make the other the second
preference for outbound....

Inbound should still overflow...

You would lose CLID... but at least the call would work...



Jonathan

On Tue, Sep 2, 2008 at 3:02 PM, Kris Seraphine <baryonyx5 at gmail.com>
wrote:

If I remember correctly, E&M-FGD will only provide incoming calls.
You need to split your circuit into two ds0-groups.  Configure one as
E&M-FGD and the other as FGD-EANA for outbound calls.

You lose quite a bit of busy hour capacity with your circuit this way
but this is how I've had to do it in the past.


On Tue, Sep 2, 2008 at 1:05 PM, Carter, Bill <bcarter at sentinel.com>
wrote:
> Need clarification. Customer has T1 CAS E&M wink circuit.
>
>
>
> How to I enable inbound Caller-ID?  FGD?
>
>
>
>
>
> If I configure a DS0-group with:
>
> ds0-group 1 timeslots 1-24 type e&m-fgd
>
>
>
> Will inbound and outbound calling still be permitted on the T1?
>
>
>

> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>



--
kris seraphine
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

 




-----------------------------------------
Disclaimer:

This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the
designated addressee(s) named above only.  If you are not the
intended addressee, you are hereby notified that you have received
this communication in error and that any use or reproduction of
this email or its contents is strictly prohibited and may be
unlawful.  If you have received this communication in error, please
notify us immediately by replying to this message and deleting it
from your computer. Thank you.