[cisco-voip] SIP to SIP call on 3740

[Luis Mata]

Hello, Folks...

  Am having problem with a cisco 3740 router configuration to be able to
do SIP to SIP calls. I have setup the services and the peers but Am not
able to complete a call. Am pretty sure my problem is on the inbound
peer. Thanks for your help


voice service voip 
 allow-connections sip to h323
 allow-connections sip to sip
 redirect ip2ip
 h323
 sip


dial-peer voice 777 voip
 voice cut-through alert
 service session
 incoming called-number 1..........
 dtmf-relay rtp-nte
 no vad
!
dial-peer voice 779 voip
 service session
 destination-pattern 1..........
 session protocol sipv2
 session target ipv4:destinationgw
!         
sip-ua    


But when  a call comes in stays dead

1w4d: //108/DFAFC264AFD1/SIP/Call/sipSPICallInfo: 
The Call Setup Information is:
Call Control Block (CCB) : 0x63FE07B0
State of The Call        : STATE_DEAD
TCP Sockets Used         : NO
Calling Number           : 7862866282
Called Number            : 13057773456
Source IP Address (Sig  ): srcip
Destn SIP Req Addr:Port  : srcip:0
Destn SIP Resp Addr:Port : srcip:5060
Destination Name         : srcip

1w4d: //108/DFAFC264AFD1/SIP/Call/sipSPIMediaCallInfo: 
Number of Media Streams: 1
Media Stream             : 1
Negotiated Codec         : g729r8
Negotiated Codec Bytes   : 0
Negotiated Dtmf-relay    : 6
Dtmf-relay Payload       : 101
Source IP Address (Media): 0.0.0.0
Source IP Port    (Media): 0
Destn  IP Address (Media): 0.0.0.0
Destn  IP Port    (Media): 20474
Orig Destn IP Address:Port (Media): 0.0.0.0:0

1w4d: //108/DFAFC264AFD1/SIP/Call/sipSPICallInfo: 
Disconnect Cause (CC)    : 65
Disconnect Cause (SIP)   : 200