[cisco-voip] voice card in 2821 router

[Michael Muscat]

Thanks!  The router was ordered with 0 DSP's since it was going to be
used just for T1 connections, but we decided to use it for some POTS
stuff as well.

 

Thanks again!

 

________________________________

From: Jason Aarons (US) [mailto:jason.aarons at us.didata.com] 
Sent: Thursday, April 23, 2009 10:48 AM
To: Michael Muscat; cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] voice card in 2821 router

 

You need to look at a show diag and see what PVDMs are installed, then
run the DSP Calculator on cisco.com to determine if you have enough DSP
resources.

 

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Michael Muscat
Sent: Thursday, April 23, 2009 8:55 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] voice card in 2821 router

 

I have a new 2821 router using "flash:c2800nm-ipvoicek9-mz.124-23.bin"
and ver 12.4(13r)T IOS.

 

I have a 2 port T1 WIC installed and working.  I added a 2 port FXO card
(VIC2-2FXO), but when the router comes back up the amber lights stay lit
on the card.  The card is being recognized in the "show ver" but it
won't let me configure any ports on it.  I thought it might be the FXO
card, but I swapped it out with 2 other new one's...same result.  The
weird part is that it's showing up in "show run" but it won't let me use
the "port" command to configure it.  Below is what the "show run" is
displaying.

 

voice-card 0

 no dspfarm

 

I have a TAC open with Cisco, and they mentioned that I don't have any
DSP's available.  I figure with only having the 2 port T1 card on a
router of this size, I should be able to add a second card.  Also, I can
create the dial-peer, but the command for to enter the port ("port
0/1/0") is not available.  I am thinking it's something with the version
of flash IOS I put on, but I have other routers using the ipvoice IOS
and it works fine. 

 

ANY THOUGHTS!?!?

 

Thanks!

 

Mike

________________________________

Disclaimer: This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the designated
addressee(s) named above only. If you are not the intended addressee,
you are hereby notified that you have received this communication in
error and that any use or reproduction of this email or its contents is
strictly prohibited and may be unlawful. If you have received this
communication in error, please notify us immediately by replying to this
message and deleting it from your computer. Thank you. 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20090423/a1ba8ba5/attachment.html>