[cisco-voip] UK PRI MGCP
VoiceNoob
voicenoob at gmail.com
Thu Dec 3 10:36:09 EST 2009
No you have done some tweaks somewhere to make a partial PRI work with MGCP.
It does not work correctly without some changes.
It may be supported by TAC but not supported by CUCM. J
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Lewis, Chris
Sent: Thursday, December 03, 2009 8:52 AM
To: Charles Goldsmith; Joe Martini (joemar2)
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] UK PRI MGCP
To let you know, I have been using 15 channels on an ISDN30 for over 2 years
- in my UK site - with no additional tweaks on CCM or the VGW's
Plus it is supported by TAC - Spoken to Joe a few times I in the past J
Chris
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Charles Goldsmith
Sent: 03 December 2009 14:36
To: Joe Martini (joemar2)
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] UK PRI MGCP
Note: Cisco CallManager does not support the configuration or use of a
fractional PRI when you use it with MGCP. If fractional PRI is necessary,
you can use H.323 instead of MGCP.
This can be found on
http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a00806fedb
e.shtml#topic1
It's not supported and won't work without some tweaking.
Charles
On Thu, Dec 3, 2009 at 8:34 AM, Joe Martini (joemar2) <joemar2 at cisco.com>
wrote:
To do a fractional MGCP T1/E1/PRI you have to configured it as a full PRI on
the gateway. Then on CUCM check the CallManager service parameter, Change
B-Channel Maintenance Status.
Joe
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Dan Greenway
Sent: Thursday, December 03, 2009 9:25 AM
To: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] UK PRI MGCP
I didn't think you could do MGCP with fractional E1's
thanks
Dan
On 3 Dec 2009, at 07:10, afatsum wrote:
You are missing l3 backhaul binding to ccm-manager under your serial
interface. Add "isdn bind-l3 ccm-manager" under serial 0/0/0:15
-Mus
Martin Bufton wrote:
I have a Cisco router connected to UK PRI E1 with 10 channels. I
cannot get it to register.
I get the following MCGP debug message. Can you see anything wrong in
my config?
000073: *Dec 2 17:55:59.251 GMT:
//-1/xxxxxxxxxxxx/MGCP/mgcp_mp_get_not_entity(830):[lvl=2]Invalid
parameter (pkt 0x67654638 pkt->mgcp_parm_lines 0x00000000)
Thanks in advance
Current configuration : 8969 bytes
!
version 12.4
no service pad
service timestamps debug datetime msec localtime show-timezone
service timestamps log datetime msec localtime show-timezone
service password-encryption
service sequence-numbers
!
hostname Cent-xxx-MGCP-GW1-RT
!
boot-start-marker
boot-end-marker
!
card type e1 0 0
logging buffered 51200 warnings
!
no aaa new-model
clock timezone GMT 0
clock summer-time BST recurring last Sun Mar 2:00 last Sun Oct 2:00
network-clock-participate wic 0
dot11 syslog
!
!
ip cef
!
!
no ip bootp server
no ip domain lookup
ip domain name
multilink bundle-name authenticated
!
isdn switch-type primary-net5
voice-card 0
no dspfarm
!
crypto pki trustpoint TP-self-signed-2117350501
enrollment selfsigned
subject-name cn=IOS-Self-Signed-Certificate-2117350501
revocation-check none
rsakeypair TP-self-signed-2117350501
quit
!
!
archive
log config
hidekeys
!
!
controller E1 0/0/0
pri-group timeslots 1-10,16 service mgcp
!
controller E1 0/0/1
!
ip tcp synwait-time 10
!
!
!
!
interface Port-channel1
description EtherChannel to Cent-xxx-Core-Sw
ip address 172.16.xx.100 255.255.255.0
!
interface GigabitEthernet0/0
description Member of Etherchannel conected to Cent-xxx-Core-Sw gig
2/0/19
no ip address
duplex auto
speed auto
media-type rj45
channel-group 1
!
interface GigabitEthernet0/1
description Member of Etherchannel conected to Cent-xx-Core-Sw gig 1/0/19
no ip address
duplex auto
speed auto
media-type rj45
channel-group 1
!
interface Serial0/0/0:15
no ip address
encapsulation hdlc
isdn switch-type primary-net5
isdn incoming-voice voice
no cdp enable
!
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 Port-channel1 172.16.xx.1
!
!
ip http server
ip http access-class 23
ip http authentication local
ip http secure-server
ip http timeout-policy idle 60 life 86400 requests 10000
!
control-plane
!
voice-port 0/0/0:15
!
ccm-manager mgcp
!
mgcp
mgcp call-agent 172.16.x.10 service-type mgcp version 1.0
!
mgcp profile default
!
dial-peer voice 1 pots
service mgcp
destination-pattern 9T
incoming called-number ....
direct-inward-dial
!
!
!
scheduler allocate 20000 1000
ntp server 172.16.74.30
!
end
* *
*Martin Bufton BSc (Hons), CCNA - *Systems Engineer**
* *
------------------------------------------------------------------------
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
Dan Greenway
UC Engineer
2e2
The Mansion House
Benham Valence
Newbury
RG20 8LU
Mobile: 07776130731
Email: dan.greenway at 2e2.com
2e2 is one of the fastest growing IT service providers in Europe. To find
out more, visit www.2e2.com
This email is from 2e2 UK Limited. The contents of this email and
any attachments are confidential to the intended recipient. They may
not be disclosed to or used by or copied in any way by anyone other
than the intended recipient. If this email is received in error,
please contact 2e2 UK Limited IT Support on +44 (0) 1635 520111 quoting the
name
of the sender and the email address to which it has been sent and
then delete it.
Please note that neither 2e2 UK Limited nor the sender accepts any
responsibility for viruses and it is your responsibility to scan or
otherwise check this email and any attachments.
2e2 UK Limited is a company registered in England with registered
number 4090390 whose registered office business is: The Mansion House
Benham Valence, Speen, Near Newbury, Berks RG20 8LU. For further
information, please refer to www.2e2.com or, for general enquiries, please
telephone +44 (0) 1635 568000.
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
The information contained in this message and its attachments
is intended only for the private and confidential use of the
intended recipient(s). If you are not the intended recipient
(or have received this e-mail in error) please notify the
sender immediately and destroy this e-mail. Any unauthorized
copying, disclosure or distribution of the material in this e-
mail is strictly prohibited.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091203/063a60d6/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/png
Size: 11804 bytes
Desc: not available
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091203/063a60d6/attachment.png>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/jpeg
Size: 27128 bytes
Desc: not available
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091203/063a60d6/attachment.jpe>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/jpeg
Size: 24708 bytes
Desc: not available
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091203/063a60d6/attachment-0001.jpe>
More information about the cisco-voip
mailing list