[cisco-voip] Callmanager 7.1.3 Release notes about Low Active Parition CSCtc99413

Jason Aarons (US) jason.aarons at us.didata.com
Mon Dec 14 19:50:53 EST 2009


This is going to be fun...high level overview...

1)	Go from 5.1(3) to 7.0(2a)
2)	then upgrade the 7.1(3b)SU1
3)	do a DRS Backup under 7.1(3b)SU1
4)	Clean Install of 7.1(3b)SU1 then a DRS Restore Wizard to fix
CSCtc99413 (5x common partition wasn't big enough)
5)	Then I suspect a clean install of each subscriber would have to
go along with this
6)	MoH file restore to each Subscriber 
7)	Downgrade the device defaults to match the other Phne Load
migration plan (otherwise the loads will be higher than we want) 
8)	Attendant Console, JTAPI, TSP Updates
9)	Then the UCCX upgrade follows....

-----Original Message-----
From: Adam Frankel [mailto:afrankel at cisco.com] 
Sent: Monday, December 14, 2009 7:33 PM
To: Jason Aarons (US)
Cc: Cisco VoIPoE List
Subject: Re: [cisco-voip] Callmanager 7.1.3 Release notes about Low
Active Parition CSCtc99413

It's the second one.  Upgrade, Backup, Clean Install, Restore.

Adam

-------- Original Message  --------
Subject: [cisco-voip] Callmanager 7.1.3 Release notes about Low Active 
Parition CSCtc99413
From: Jason Aarons (US) <jason.aarons at us.didata.com>
To: Cisco VoIPoE List <cisco-voip at puck.nether.net>
Date: 12/14/09 6:04 PM

Do I understand the fix for bug CSCtc99413 is to run DRS in 5.1.3 and
then restore that 5.1.3 DRS file in 7.1.3a?  I thought you could only
restore exactly same eg 5.1.3 backup with DRS must restore to 5.1.3.

 

Or is the fix to upgrade to 7.1.3a, then do a DRS under 7.1.3a, then
clean install  7.1.3a, the restore my 7.1.3a DRS file?

 

I'm going from 5.1.3 to 7.1.3a (7.1.3.21901-1)

 

CallManager 7.1.3a Release Notes

https://www.cisco.com/en/US/docs/voice_ip_comm/cucm/rel_notes/7_1_3/cucm
-rel_notes-713a.html

 

*CSCtc99413 * Upgrade from 5.1.3 to 7.1.3a results in LowActivePartition
DiskSpace. **
*Symptom:*

If the last fresh install was 5.x, then when upgrading to 7.1.3 or
greater, we see low active partition disk alerts.

*Conditions:*

System must have once been on a 5.x release, with no fresh installs
since then.
Must be upgrading to 7.1.3 or greater release.

*Workaround:*

Perform the following steps:
Lower the threshold for the low active partition disk space warning to
less than 4%.
Backup your system.
Perform a fresh installation.
Restore the system so that the disk is repartiitoned and is no longer
limited by the inefficient 5.x disk partitioning.

------------------------------------------------------------------------

* Disclaimer: This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the designated
addressee(s) named above only. If you are not the intended addressee,
you are hereby notified that you have received this communication in
error and that any use or reproduction of this email or its contents is
strictly prohibited and may be unlawful. If you have received this
communication in error, please notify us immediately by replying to this
message and deleting it from your computer. Thank you. *


------------------------------------------------------------------------

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

-----------------------------------------
Disclaimer:

This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the
designated addressee(s) named above only.  If you are not the
intended addressee, you are hereby notified that you have received
this communication in error and that any use or reproduction of
this email or its contents is strictly prohibited and may be
unlawful.  If you have received this communication in error, please
notify us immediately by replying to this message and deleting it
from your computer. Thank you.


More information about the cisco-voip mailing list