[cisco-voip] CSIM Start Command

[Turpin, Mark]

There is a disconnect cause code that should lend insight.

 

You should couple the command with helpful debugs like 'debug voip
dialpeer all'

 

The following may be helpful as well:

http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a00800
94045.shtml

 

hth,

-mark

 

--

MARK TURPIN  |  SE  |  CCIE 21649 |  Insight Networking |
www.insight.com

Single Number Reach: +1-314-656-2315  mark.turpin at insight.com
<mailto:mark.turpin at insight.com>  

 

The information contained in this message and any attachment may contain
privileged or confidential information protected from disclosure. If you
are not the intended recipient, or an employee or agent responsible for
delivering this message to the intended recipient, you are hereby
notified that any review, dissemination, distribution or copying of this
information is strictly prohibited.  If you have received this
transmission in error, please notify the sender immediately by replying
to this message and destroying the original and all copies.  Thank you.

 

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of John Huston
Sent: Tuesday, December 29, 2009 3:05 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] CSIM Start Command

 

How do you tell if  you have a successful call or not using the CSIM
Start <Number> command?



 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20091229/5c5a8f08/attachment.html>