[cisco-voip] how to strip leading number in calling party

[abuch]

Dear Peter,

I have asked the telco and for called number starting with 095 they
expect national type and plan. So I used the follwing config snippet:

voice translation-rule 4
 rule 1 /^095\(.......\)/ /95\1/ type unknown national plan unknown national
!
dial-peer voice 13 pots
 destination-pattern 86T
 translate-outgoing called 4
 fax rate disable
 port 2/1:15

But I am not able to change the type and plan. The leading 0 in the
calling numebr is already stripped in the calling party transform mask
in CCM.

best regards,

Abebe A.
On 2/11/09, Peter Slow <peter.slow at gmail.com> wrote:
> Dear Anon,
>     I would recommend finding out what your telco expects you to send
> as your called plan and type - you can see here that you are sending
> unknown for both:
>
>>         Called Party Number i = 0x80, '0959502203'
>>                 Plan:Unknown, Type:Unknown
>
> ...And you likely need to be sending national or something to that
> effect, if you are indeed dialing your number correctly. Im under the
> impression that you are dialing within your own country and that this
> is not an international call.
>
> If you need to strip the leading 0, you need to use a translation rule
> in IOS, it can be done rather easily. make sure you're sending the
> correct plan and type first. you can set this with the translation
> rule as well. Apply it outbound on your pots dial-peer.
>
> -Peter
>
> On Wed, Feb 11, 2009 at 10:30 AM, abuch <abucho at gmail.com> wrote:
>> Dear all,
>>
>> CUCM 6.1.3-100016, Cisco 3845 H.323 gw connected to the PSTN with ISDN
>> PRI.
>> Outgoing calls to the PSTN are appearing to have a leading additional 0.
>> The
>> DID number range I am using is 095960XXXX. I have configured calling
>> party
>> trasformation mask as 95960XXXX. But when I make calls to the PSTN the
>> CLID
>> displayed as 0095960XXXX.
>> The output of debug isdn q931:-
>>
>> Feb 11 15:01:47.051: ISDN Se2/1:15 Q931: Applying typeplan for sw-type
>> 0x12
>> is 0x0 0x0, Calling num 959602203
>> Feb 11 15:01:47.051: ISDN Se2/1:15 Q931: Applying typeplan for sw-type
>> 0x12
>> is 0x0 0x0, Called num 0959502203
>> Feb 11 15:01:47.051: ISDN Se2/1:15 Q931: TX -> SETUP pd = 8  callref =
>> 0x01B3
>>         Sending Complete
>>         Bearer Capability i = 0x8090A3
>>                 Standard = CCITT
>>                 Transfer Capability = Speech
>>                 Transfer Mode = Circuit
>>                 Transfer Rate = 64 kbit/s
>>         Channel ID i = 0xA9839F
>>                 Exclusive, Channel 31
>>         Calling Party Number i = 0x0081, '959602203'
>>                 Plan:Unknown, Type:Unknown
>>         Called Party Number i = 0x80, '0959502203'
>>                 Plan:Unknown, Type:Unknown
>> Feb 11 15:01:47.195: ISDN Se2/1:15 Q931: RX <- CALL_PROC pd = 8  callref
>> =
>> 0x81B3
>>         Channel ID i = 0xA9839F
>>                 Exclusive, Channel 31
>> Feb 11 15:01:51.159: ISDN Se2/1:15 Q931: RX <- ALERTING pd = 8  callref =
>> 0x81B3
>>         Progress Ind i = 0x8488 - In-band info or appropriate now
>> available
>> Feb 11 15:02:07: %ISDN-6-DISCONNECT: Interface Serial2/1:0  disconnected
>> from 0959502812 , call lasted 62 seconds
>> Feb 11 15:02:07.472: ISDN Se2/1:15 Q931: TX -> DISCONNECT pd = 8  callref
>> =
>> 0xF400
>>         Cause i = 0x8090 - Normal call clearing
>> Feb 11 15:02:07.632: ISDN Se2/1:15 Q931: RX <- RELEASE pd = 8  callref =
>> 0x7400
>> Feb 11 15:02:07.632: ISDN Se2/1:15 Q931: TX -> RELEASE_COMP pd = 8
>> callref
>> = 0xF400
>> Feb 11 15:02:11.408: ISDN Se2/1:15 Q931: TX -> DISCONNECT pd = 8  callref
>> =
>> 0x01B3
>>         Cause i = 0x8090 - Normal call clearing
>> Feb 11 15:02:11.672: ISDN Se2/1:15 Q931: RX <- RELEASE pd = 8  callref =
>> 0x81B3
>> Feb 11 15:02:11.672: ISDN Se2/1:15 Q931: TX -> RELEASE_COMP pd = 8
>> callref
>> = 0x01B3
>>
>>
>> What can I do in order to remove the additional 0? or is it a telcom
>> issue?
>>
>>
>> _______________________________________________
>> cisco-voip mailing list
>> cisco-voip at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>
>>
>