[cisco-voip] Voice source group

[Jeremy Rogers]

So I cant use what is outlined in this doc?

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a00803f818a.shtml#con10a

Jeremy Rogers
Network Management
IPsoft, Inc.
Jeremy.Rogers at ip-soft.net
Phone: 888.IPSOFT8
http://www.ipsoft.com



-----Original Message-----
From: matthn at gmail.com [mailto:matthn at gmail.com] On Behalf Of Nick Matthews
Sent: Wednesday, July 15, 2009 5:15 PM
To: Voice Noob
Cc: Jeremy Rogers; cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Voice source group

This isn't currently available, but it's something that was on the
roadmap I believe.  I would check back in on this in 6 mos to a year.

For now, I would stick to incoming called-number and answer-address,
along with traditional prefixing of digits.

-nick

On Wed, Jul 15, 2009 at 4:49 PM, Voice Noob<voicenoob at gmail.com> wrote:
> Never tried to match on subnet. Good luck.
>
>
>
> From: Jeremy Rogers [mailto:Jeremy.Rogers at ip-soft.net]
> Sent: Wednesday, July 15, 2009 3:48 PM
> To: Voice Noob; cisco-voip at puck.nether.net
> Subject: RE: [cisco-voip] Voice source group
>
>
>
> What I need to do is take calls hitting an AS5400 via SIP and have them
> route to a specific POTS dial peer out to the PSTN.
>
>
>
> Jeremy Rogers
>
> Network Management
>
> IPsoft, Inc.
>
> Jeremy.Rogers at ip-soft.net
>
> Phone: 888.IPSOFT8
>
> http://www.ipsoft.com
>
>
>
>
>
> From: Voice Noob [mailto:voicenoob at gmail.com]
> Sent: Wednesday, July 15, 2009 4:46 PM
> To: Jeremy Rogers; cisco-voip at puck.nether.net
> Subject: RE: [cisco-voip] Voice source group
>
>
>
> Don't know about that but you could match their extension range on an
> incoming dial-peer and add a different access code to the begging of the
> dialed number with a translation rule. Then have a set of dial-peers that
> matches that access code.
>
>
>
> From: cisco-voip-bounces at puck.nether.net
> [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jeremy Rogers
> Sent: Wednesday, July 15, 2009 3:03 PM
> To: cisco-voip at puck.nether.net
> Subject: [cisco-voip] Voice source group
>
>
>
> Can I use the voice source-group command to route traffic coming from
> specific 172.16.x.x addresses to specific POTS dial peers?
>
>
>
> Jeremy Rogers
>
> Network Management
>
> IPsoft, Inc.
>
> Jeremy.Rogers at ip-soft.net
>
> Phone: 888.IPSOFT8
>
> http://www.ipsoft.com
>
>
>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>