[cisco-voip] Calls from analog phone to IP phone

[Paul]

No, I just mean using the H323 gateway with SCCP to register the FXS ports only.

http://www.cisco.com/en/US/docs/ios/voice/fxs/configuration/guide/fxssccpsplmft.html



----- Original Message ----
From: Shine Joseph <shinejoseph at dodo.com.au>
To: Paul <asobihoudai at yahoo.com>; cisco-voip at puck.nether.net
Sent: Monday, June 1, 2009 4:22:29 PM
Subject: Re: [cisco-voip] Calls from analog phone to IP phone

Thanks Paul for the quick reply.

Do you mean using the GW as MGCP and registering the FXS ports is the recommended way. I am not really stuck with H323.

Thanks,
Shine

----- Original Message ----- From: "Paul" <asobihoudai at yahoo.com>
To: "Shine Joseph" <shinejoseph at dodo.com.au>; <cisco-voip at puck.nether.net>
Sent: Monday, June 01, 2009 10:09 PM
Subject: Re: [cisco-voip] Calls from analog phone to IP phone


> 
> Unless you're strictly bound to using H.323 for these FXS ports, I'd highly recommend you upgrade your IOS to a version that supports SCCP control of your FXS ports (if your current version does not already), and configure them to use SCCP so you can simply register the ports just like any other IP phone. It's a lot easier.
> 
> 
> 
> 
> ________________________________
> From: Shine Joseph <shinejoseph at dodo.com.au>
> To: cisco-voip at puck.nether.net
> Sent: Monday, June 1, 2009 1:38:05 AM
> Subject: [cisco-voip] Calls from analog phone to IP phone
> 
> 
> Hi
> Folks,
> 
> I am
> running a CUCM7 and a H323 gateway with a couple of FXS ports. Have created a
> route pattern for calls to the analog phones connected to the FXS ports on the
> gateway and the calls from IP phones to these analog phones work as expected.
> But, when I try to  call from analog phone to an IP phone, I am getting a
> message from saying the number do not exists. I can see the the calls match the
> incoming and outgoing dial-peers on the gateway. My dial-peers on the gateway as
> follows:
> 
> dial-peer voice 1 pots
> trunkgroup BRI 1
> description *** Inbound POTS dial peer for incoming PSTN calls
> ***
> destination-pattern 0T
> progress_ind alert enable 8
> progress_ind progress enable 8
> progress_ind connect enable 8
> incoming called-number .
> direct-inward-dial
> !
> dial-peer voice 33582 pots
> description *** Analog line 33582 ***
> destination-pattern 33582
> no digit-strip
> port 0/1/1
> !
> dial-peer voice 33 voip
> destination-pattern 33500
> session target ipv4:10.10.210.10
> 
> I think
> very simple needs to be done in the callmanager to get the calls through, but
> cannot work out what should be done.
> 
> Any
> help  or pointers are much appreciated.
> 
> Thanks
> in advance,
> 
> Shine
> Joseph
> 
> 
> 
>