[cisco-voip] Help with first time VOIP setup.

[Paul]

Then make it an ephone by registering your FXS port using SCCP.

It's easier that way...


----- Original Message ----
From: Anthony R. Mattke <a.mattke at gmail.com>
To: Paul <asobihoudai at yahoo.com>
Cc: cisco-voip at puck.nether.net
Sent: Tuesday, June 16, 2009 10:12:37 PM
Subject: Re: [cisco-voip] Help with first time VOIP setup.

One of them isn't an ephone. Its a FXS port using a dial-peer such as..

!
dial-peer voice 55 pots
destination-pattern 55
port 1/1
!

And then a ephone-dn that I want to use the same extension, or make ring at the same time so either can answer the call..

Paul wrote:
> Use overlay.
> 
> Assign ephone one and two the same extension originating from two separate ephone-DNs and then use overlay to have them both ring.
> 
> 
> ----- Original Message ----
> From: Anthony R. Mattke <a.mattke at gmail.com>
> To: cisco-voip at puck.nether.net
> Sent: Tuesday, June 16, 2009 6:13:32 PM
> Subject: Re: [cisco-voip] Help with first time VOIP setup.
> 
> Ok, so today, I've been attempting to have two phones ring for the same extension.
> 
> I see this is fairly simple if they're both ephones, but what about 1 ephone and 1 pots ? I can't seem to make this work, and I can't find any documentation regarding setting this up.
> 
> -Tony
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
> 
> 
> 
>