[cisco-voip] About HT502 ATA device.

[cem caglayan]

Hi there,

I could manage to add HT502 to CUCM 6.0 as a basic SIP device. As you know,
it has two fxo ports, but only one could be registered if done so.

So i added it as an advanced SIP device, this time both fxo ports seems
registered in ATA device config page, but in CUCM it says partially
registered, so i can not make the both fxo ports operate at the same time...


Is there any suggestions about this issue?

Thanks in advance.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20090629/bdfbe53c/attachment.html>