[cisco-voip] IP phones continue to ring after hang up

[Voice Noob]

Put those in and did not resolve my issue. Thanks for the help though. I
don't think this is a gateway problem.

-----Original Message-----
From: Syed Khalid Ali [mailto:syed.khalid.khursheed at gmail.com] 
Sent: Tuesday, May 05, 2009 11:02 AM
To: Voice Noob
Cc: Paul; cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] IP phones continue to ring after hang up

I had the same issue, IP phones continue to ring even if the caller
disconnects the call. Read the document "FXO Disconnect Problem" at:
http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a0080
0ae2d1.shtml

The following config solved my problem:
voice-port 0/0/0
 supervisory disconnect dualtone mid-call
 supervisory answer dualtone
 no battery-reversal
 no vad
 cptone PK
 timeouts call-disconnect 1
 timeouts wait-release 1
 timing hookflash-out 500
 connection plar opx 2221
 description ** Direct Line -- 1 **
 caller-id enable

I hope this helps!

-- 
Thanks,
Syed Khalid Ali


On Tue, May 5, 2009 at 8:55 PM, Voice Noob <voicenoob at gmail.com> wrote:
> It will ring until someone picks up an IP phone.
>
> -----Original Message-----
> From: Paul [mailto:asobihoudai at yahoo.com]
> Sent: Tuesday, May 05, 2009 10:45 AM
> To: Voice Noob; cisco-voip at puck.nether.net
> Subject: Re: [cisco-voip] IP phones continue to ring after hang up
>
>
> And this continues to ring for more than 10 rings or just a few?
>
> It's a common issue with FXO ports that when someone on the calling
party's
> side hangs up before the called party picks up, the IP phone can ring a
few
> more times before actual termination completes.
>
>
>
>
> ________________________________
> From: Voice Noob <voicenoob at gmail.com>
> To: cisco-voip at puck.nether.net
> Sent: Tuesday, May 5, 2009 11:31:33 AM
> Subject: [cisco-voip] IP phones continue to ring after hang up
>
>
>                Call
> starts via FXO port on H.323 gateway. PLAR is sent to Unity connection
which
> does
> TOD check and then sends the call to a Hunt Pilot number for a broadcast
> hunt
> group. If I hang the call up from the PSTN side the call continues to
ring.
> If
> I take Unity out of the picture and send the call directly to the Hunt
pilot
> everything works correctly.
>
>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>