[cisco-voip] vmwi and VG224/SCCP show stcapp device voice-port 0/3/3

[Spoon, Rusty]

We've got it working on 6.1 (1) without any significant problems.  SCCP
was required.

RS


-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jason Aarons
(US)
Sent: Tuesday, May 19, 2009 12:42 PM
To: Cisco VOIP
Subject: [cisco-voip] vmwi and VG224/SCCP show stcapp device voice-port
0/3/3

I wanted some verification but I understand for Stutter (Audible MWI)
works with VG224 so long as below is meet.  Can someone affirm they have
Stutter dial tone on analog phone working with VG224/SCCP and
CallManager 6x or 7x?


VG224 has to be SCCP for Audible MWI
 
http://www.gossamer-threads.com/lists/engine?do=post_view_printable;post
=70176;list=cisco
 
 
 
have VMWI working on an ISR router with FXS ports (VMWI will work on a
VG224 as well). Basically below are the requirements:
 
*        The Cisco Gateway must run IOS version IP Voice T strain (not
SP Services on ISRs) 12.4(6)T or later (I tested 12.4(11)T2)
 
*        Cisco CallManager version must be version 4.2 or later (I
tested CallManager 5.1.2)
 
*        Any version of Unity (I tested Unity Connection 1.2)
 
*        Must use SCCP(Skinny) as the gateway protocol, and NOT MGCP
 
Here is an output from the gateway(MWI refers to stutter tone VMWI needs
to be "ON"):
 
pstn#show stcapp device voice-port 0/3/3
 
Port Identifier:  0/3/3
 
Device Type:      ALG 
 
Device Id:        4
 
Device Name:      AN17598075F0183
 
Modem Capability: None
 
Device State:    IS
 
Diagnostic:      None
 
Directory Number: 1005
 
Dial Peer(s):    101 
 
Dialtone after remote onhook feature: activated
 
Last Event:       STCAPP_CC_EV_CALL_DISCONNECT_DONE
 
Line State:       IDLE
 
Hook State:       ONHOOK
 
mwi:             ENABLE
 
vmwi:            ON
 
PLAR:            DISABLE
 
Number of CCBs:   0
 
Global call info:
 
    Total CCB count      = 0
 
    Total call leg count = 0
 



________________________________

Disclaimer: This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the designated
addressee(s) named above only. If you are not the intended addressee,
you are hereby notified that you have received this communication in
error and that any use or reproduction of this email or its contents is
strictly prohibited and may be unlawful. If you have received this
communication in error, please notify us immediately by replying to this
message and deleting it from your computer. Thank you.