[cisco-voip] 2801 router and VWIC2-1MFT-T1/E1 card

[Vigar, Damien]

Hi all,

I would like to use a 2801 ISR with a VWIC2-1MFT-T1/E1 to terminate an E1 circuit with 10 voice channels (it's a Telstra OnRamp30 with 10 lines) at one of our smaller sites. The 2801 has enough capacity for SRST etc. to support the site.

However, when I add the configs to the router:
controller E1 0/0/0
 pri-group timeslots 1-10,16

I get this error:

%Insufficient resources to create pri-group - it has been removed

The config is a duplicate of an in-service 2811 router. The only difference is that the current router is a 2801. I thought it might be a lack of DSP resources, so I tried it with a PVDM2-16 module replacing the PVDM2-8 module that is installed. The 2801 saw the 16 voice channel resources, but I got the same error.

Everything I can find says that the 2801 is compatible with the VWIC2 card. Am I out of luck here?

Cheers,

Damien



**********************************************************************
This message is intended for the addressee named and may contain
privileged information or confidential information or both. If you
are not the intended recipient please delete it and notify the sender.
**********************************************************************