[cisco-voip] New PRI card

[Ratko Dodevski]

Thanks Mike... when you said it... i remember it... i have done this 2-3
times :))) the command is card type E1... and so on

Thanks

Ratko

On Tue, Sep 15, 2009 at 9:46 PM, Norton, Mike <mikenorton at pwsd76.ab.ca>wrote:

>  If your new card is one of the ones that can do both T1 and E1, then you
> have to tell it which you want it to be before any of the usual commands
> will be accepted. Don’t remember the exact command to do that off the top of
> my head, but I do remember struggling through that the first time I used one
> of those cards.
>
>
>
> --
>
> Mike Norton
>
> I.T. Support
>
> Peace Wapiti School Division No. 76
>
> Helpdesk: 780-831-3080
>
> Direct: 780-831-3076
>
>
>
> *From:* cisco-voip-bounces at puck.nether.net [mailto:
> cisco-voip-bounces at puck.nether.net] *On Behalf Of *Ratko Dodevski
> *Sent:* September-15-09 1:40 PM
> *To:* cisco-voip at puck.nether.net
> *Subject:* [cisco-voip] New PRI card
>
>
>
> Hi all,
> in sh run i get this card type command needed for slot/vwic-slot 0/0. I
> guess I need to enter network-clock-participate wic 0 to enable the new PRI
> card, but it doesn't accept the command. What am I doing wrong. The only
> network-clock-participate is wic 1 and that is the BRI card.
>
> Thanks
> Regards
>
> --
> Ratko
>



-- 
Ratko
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20090915/028f5077/attachment.html>