[cisco-voip] [c-nsp] 2420 IAD BERT Problem

[Clue Store]

Hi All,

I am having an issue with an old IAD unit that I am trying to get up and
working. I am getting the following error message in console with a clean
config. I cannot seem to get s0 up even with a loop cable even though a
"show controller t1 0" does show up wth a loop cable. Anyone know how to
disable the BERT error?? I've tried several different images in the 12.2 and
the 12.3 train with no luck.


*Mar  1 02:11:58.679: %LINK-6-BERTMSGS: Configuration not accepted, BERT is
running


Router#sho ver

Cisco Internetwork Operating System Software

IOS (tm) IAD2420 Software (C2420-A2I8SV5-M), Version 12.3(25), RELEASE
SOFTWARE (fc1)

Copyright (c) 1986-2008 by cisco Systems, Inc.

Compiled Mon 28-Jan-08 18:32 by alnguyen



ROM: System Bootstrap, Version 12.2(2r)T2, RELEASE SOFTWARE (fc1)

ROM: IAD2420 Software (C2420-WBOOT-M), Version 12.1(5r)XR1,  RELEASE
SOFTWARE (fc1)



Router uptime is 2 hours, 11 minutes

System returned to ROM by power-on

System image file is "flash:c2420-a2i8sv5-mz.123-25.bin"



Cisco IAD2420 (MPC860P) processor (revision 240.06) with 61440K/4096K bytes
of memory.

Processor board ID 26843815

PPC860 PowerQUICC, partnum 0x0005, version X02(0x0002)

Channelized E1, Version 1.0.

Bridging software.

Primary Rate ISDN software, Version 1.1.

IAD2420 SCB board (v01.B0), FPGA version 0.6

1 Multiflex T1(slot 3) RJ45 interface(v03.A0)

1 Sixteen FXS Analog Voice Module (v02.A0)

1 High Density Analog Power Module (v01.A0)

1 4-DSP(slot2) High Performance Compression Module(v01.A0)

1 Ethernet/IEEE 802.3 interface(s)

1 Serial(sync/async) network interface(s)

1 terminal line(s)

1 Channelized T1/PRI port(s)

256K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (AMD29F016)



Configuration register is 0x2102



TIA,

Clue
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20090928/6eb14687/attachment.html>