[cisco-voip] SIP gateway config
Ahmed Elnagar
ahmed_elnagar at rayacorp.com
Mon Apr 26 17:29:11 EDT 2010
I think you can force early offer from the gateway to avoid using MTP.
Best Regards;
Ahmed Elnagar
Senior Network PS Engineer
Mob: +2019-0016211
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Ryan Ratliff
Sent: Monday, April 26, 2010 11:19 PM
To: miken miken
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] SIP gateway config
Only if you need SIP early media from CUCM.
-Ryan
On Apr 26, 2010, at 5:06 PM, miken miken wrote:
MTP configured and box checked mandatory in SIP trunk configuration on
CUCM?
Thanks
MikeN
On Mon, Apr 26, 2010 at 3:00 PM, Brian Schultz <bms314 at gmail.com> wrote:
Yep, have that already. Gig0/1.110 has the IP address configured on the
SIP trunk in CUCM.
voice service voip
sip
bind control source-interface GigabitEthernet0/1.110
bind media source-interface GigabitEthernet0/1.110
I also have the following:
voice class codec 1
codec preference 1 g711ulaw
codec preference 2 g729r8
dial-peer voice 100 voip
destination-pattern ....
session protocol sipv2
session target ipv4:172.21.20.10
voice-class codec 1
dtmf-relay rtp-nte
no vad
dial-peer voice 1 pots
incoming called-number .
direct-inward-dial
On Mon, Apr 26, 2010 at 3:58 PM, Ahmed Elnagar <
ahmed_elnagar at rayacorp.com> wrote:
You have to bind signal and media traffic out of the router to the CUCM
with the IP address you have configured on CUCM "by default CUCM reject
calls with source address other than the configured"
Try the below on the gateway:
voice service voip
sip
bind all source-interface "interface configured on CUCM"
Best Regards;
Ahmed Elnagar
Senior Network PS Engineer
Mob: +2019-0016211
ccie_voice_large.gif<x-msg://347/> ccvp_voice_large.gif<x-msg://347/>
From: cisco-voip-bounces at puck.nether.net [mailto:
cisco-voip-bounces at puck.nether.net] On Behalf Of Brian Schultz
Sent: Monday, April 26, 2010 10:34 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] SIP gateway config
Does anyone happen to have an example SIP gateway config for an ISR?
CUCM 8.0(2) with a SIP trunk to a 2921 gateway (15.0.M1.12) with a
standard PRI for PSTN access. I have outbound working, but inbound
gives a fast busy with a 401 Unauthorized in the SIP debug.
Thanks,
Brian
Disclaimer: NOTICE The information contained in this message is
confidential and is intended for the addressee(s) only. If you have
received this message in error or there are any problems please notify
the originator immediately. The unauthorized use, disclosure, copying or
alteration of this message is strictly forbidden. Raya will not be
liable for direct, special, indirect or consequential damages arising
from alteration of the contents of this message by a third party or as a
result of any malicious code or virus being passed on. Views expressed
in this communication are not necessarily those of Raya.If you have
received this message in error, please notify the sender immediately by
email, facsimile or telephone and return and/or destroy the original
message.
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
Disclaimer: NOTICE The information contained in this message is confidential and is intended for the addressee(s) only. If you have received this message in error or there are any problems please notify the originator immediately. The unauthorized use, disclosure, copying or alteration of this message is strictly forbidden. Raya will not be liable for direct, special, indirect or consequential damages arising from alteration of the contents of this message by a third party or as a result of any malicious code or virus being passed on. Views expressed in this communication are not necessarily those of Raya.If you have received this message in error, please notify the sender immediately by email, facsimile or telephone and return and/or destroy the original message.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100426/70cb9a7a/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/jpeg
Size: 1801 bytes
Desc: image001.jpg
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100426/70cb9a7a/attachment.jpe>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/jpeg
Size: 1806 bytes
Desc: image002.jpg
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100426/70cb9a7a/attachment-0001.jpe>
More information about the cisco-voip
mailing list