[cisco-voip] VG204 Call Hang Up Issue

[Steer, Selby]

Hi Guys,

We currently have a VG204 set up as a SCCP gateway in Call Manager 7 with two analogue devices configured off the VG204.

When calling from one device to the other the call rings twice and then hangs up for no reason.

Has anyone run into this issue before and if so, how have you rectified it?


Current Gateway config is as follows:

stcapp ccm-group 100
stcapp
!
stcapp feature access-code
!
stcapp feature speed-dial

voice-port 0/0
 timeouts initial 60
 timeouts interdigit 60
 timeouts ringing infinity
 caller-id enable type 2

voice-port 0/1
 timeouts initial 60
 timeouts interdigit 60
 timeouts ringing infinity
 caller-id enable type 2

!

ccm-manager fax protocol cisco
ccm-manager config server X.X.X.X
ccm-manager sccp local FastEthernet0/0
ccm-manager sccp
!
sccp local FastEthernet0/0
sccp ccm X.X.X.X identifier 2 priority 2 version 7.0+
sccp ccm X.X.X.X identifier 1 priority 1 version 7.0+
sccp ip precedence 3
sccp
!
sccp ccm group 100
 bind interface FastEthernet0/0
 associate ccm 1 priority 1
 associate ccm 2 priority 2
!
!
dial-peer voice 1000 pots
 service stcapp
 port 0/0
!
dial-peer voice 1001 pots
 service stcapp
 port 0/1



Cheers,
Selby Steer




Plan ahead these school holidays with RACQ's online trip planner - and don't forget to pack Ultra Care for additional travel benefits following a breakdown. Some conditions apply. Visit http://www.racq.com.au for details.

Please Note: If you are not the intended recipient, please delete this email as its use is prohibited. RACQ does not warrant or represent that this email is free from viruses or defects. If you do not wish to receive any further commercial electronic messages from RACQ please e-mail unsubscribe at racq.com.au or contact RACQ on 13 19 05.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100430/7ca8621e/attachment.html>